User manual

Operation 47
Shutting down the projector
1. Press POWER or OFF and a confirmation message will appear prompting
you.
If you don't respond in a few seconds, the message will disappear.
2. Press POWER or OFF a second time. The POWER indicator light
flashes orange, the projection lamp shuts down, and the fans will continue to run for
approximately 90 seconds to cool down the projector.
To protect the lamp, the projector will not respond to any commands during the cooling
process. To shorten the cooling time, you can also activate the Quick Cooling function. See
"Quick Cooling" on page 57 for details.
3. Once the cooling process finishes, a "Power
Off Ring Tone" will be heard. The POWER
indicator light is a steady orange and fans
stop. Disconnect the power cord from the
power outlet.
• To turn off the power ring tone, see "Turning off the
Power on/off ring tone" on page 45 for details.
• If the projector is not properly shut down, to protect
the lamp, when you attempt to re-start the
projector, the fans will run for a few minutes to cool down. Press
POWER or ON
again to start the projector after the fans stop and the POWER indicator light turns orange.
• Lamp life results will vary depending on environmental conditions and usage.