Operation Manual

Operation 23
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either
the top or bottom. It occurs when the projector is not perpendicular to the screen.
You can correct this automatically following these steps:
1. Press MENU and then press / until the DISPLAY menu is highlighted.
2. Press to highlight Auto Keystone and press / to select On.
To manually correct this, you will need to
follow these steps:
1. Do one of the following steps to
display the keystone correction page.
•Press KEYSTONE on the
remote control.
•Press QUICK INSTALL on the remote control. Press to highlight
Keystone and press OK.
•Press MENU and then press / until the DISPLAY menu is highlighted.
Press to highlight Keystone and press OK.
2. The Keystone correction page displays. Press to correct keystoning at the top
of the image. Press to correct keystoning at the bottom of the image.
Adjusting Corner Fit
You can manually adjust four corners of the image by setting the horizontal and vertical
values.
1. Do one of the following steps to display the
corner fit correction page.
•Press QUICK INSTALL on the remote
control. Press to highlight Corner Fit
and press OK.
•Press MENU and then press / until
the DISPLAY menu is highlighted. Press
to highlight Corner Fit and press OK.
2. Press / / / to select one corner and
press OK.
Press .
Press .
Corner Fit
BackEnter