Operation Manual

Operation24
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either
the top or bottom. It occurs when the projector is not perpendicular to the screen.
You can correct this automatically following these steps:
1. Press MENU and then press / until the DISPLAY menu is highlighted.
2. Press to highlight Auto Keystone and press / to select On.
To manually correct this, you will need to
follow these steps:
1. Do one of the following steps to
display the keystone correction page.
•Press KEYSTONE on the
remote control.
•Press QUICK INSTALL on
the remote control. Press
to highlight 2D Keystone and
press OK.
•Press MENU and then press
/ until the DISPLAY
menu is highlighted. Press
to highlight 2D Keystone and
press OK.
2. The 2D Keystone correction page
displays. Press to correct
keystoning at the top of the image.
Press to correct keystoning at
the bottom of the image. Press on the projector to correct keystoning at the right
side of the image. Press on the projector to correct keystoning at the left side of
the image.
Adjusting Corner Fit
You can manually adjust four corners of the image by setting the horizontal and vertical
values.
1. Do one of the following steps to display the
corner fit correction page.
•Press QUICK INSTALL on the remote
control. Press to highlight Corner Fit
and press OK.
•Press MENU and then press / until
the DISPLAY menu is highlighted. Press
to highlight Corner Fit and press OK.
2. Press / / / to select one corner and
press OK.
Press .
Press .
Press .
Press .
2D Keystone
Back
Corner Fit
Back
Enter