User's Manual

Startup 13
Startup
First time startup
After you have installed the battery and finished charging it, you are ready to power ON your
PDA phone. The first time you power ON the phone, you will be guided through a series of
setup screens. Follow the steps below to start up your phone and complete the initial setup.
1. With the battery lock in the lock position, press Power to power ON the phone.
2. Wait for the phone to boot up with the BenQ-Siemens screen.
3. On the Windows Mobile screen, tap the stylus anywhere on the screen to proceed.
4. During the
align screen process, aim and tap the stylus precisely on the cross-hair object. The
cross-hair object will move around the screen several times until the screen is aligned. Each
time the cross-hair object moves to a new location, aim and tap it.
5. Select the time zone of your location, and then tap
Next.
6. The message shows you how the stylus works. You can single tap to select an item/command,
or tap and hold (long tap) for a menu (where available). Tap
Next.
7. Tap and hold the 9 A.M. time slot to bring up a pop-up menu. Select
Cut from the pop-up
menu.
8. Tap and hold the 11 A.M. time slot to bring up a pop-up menu. Select
Paste from the pop-up
menu. Tap
Next to continue.
9. Tap
Next to enter a password if you want to protect the access to your data and available
networks while using the PDA phone. If you do not need the password, tap
Skip.
10. Tap anywhere on the final screen to exit setup.
P51_EN.book Page 13 Tuesday, August 15, 2006 5:16 PM