Operation Manual

Introduction 15
Replacing the remote control battery
1. To open the battery cover, turn the remote control
over to view its back, push on the finger grip on the
cover and slide it up in the direction of the arrow as
illustrated. The cover will slide off.
2. Remove any existing batteries (if necessary) and install
two AA batteries observing the battery polarities as
indicated in the base of the battery compartment.
Positive (+) goes to positive and negative (-) goes to
negative.
3. Refit the cover by aligning it with the base and sliding
it back down into position. Stop when it clicks into
place.
• Avoid excessive heat and humidity.
• There may be battery damage if the battery is incorrectly
replaced.
• Replace only with the same or equivalent type
recommended by the battery manufacturer.
• Dispose of the used battery according to the battery manufacturer’s instructions.
• Never throw a battery into a fire. There may be danger of an explosion.
• If the battery is dead or if you will not be using the remote control for a long time, remove
the battery to prevent damage to the remote control from possible battery leakage.