Operation Manual

Operation 59
5. System Setup: Advanced menu
Standby
Settings
Network
• Enable Network Standby Mode
Selecting On enables the function. The projector is able to
provide the network function in standby mode. Selecting Off
disables the function. The projector does not provide the
network function in standby mode.
• Auto Disable Network Standby Mode
Allows the projector to disable the network function after a set
period of time after it enters standby mode. For instance, if 20
min is selected, the projector is able to provide the network
function for 20 minutes after it enters standby mode. When 20
minutes is up, the projector enters normal standby mode.
This function is only available when Enable Network Standby
Mode is On.
Monitor Out
Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the COMPUTER 1 jack is
correctly connected to devices. See
"Connection" on page 25 for how
to make the connection.
Audio Pass Through
Press ◄/► to choose the source that you wish to use in operation
mode. See
"Connection" on page 25 for how to make the connection.
When the corresponding jacks are correctly connected to the
device, the projector can output an audio signal to the external
speaker when it is in standby mode. The built-in speaker(s) will be
muted in standby mode.
Enabling this function slightly increases the standby power
consumption.
Network
settings
Wired LAN
See BenQ Network Projector Operation Guide for details.
AMX Device Discovery
When AMX Device Discovery is On, the projector can be
detected by AMX controller.
MAC Address
Displays the MAC Address for this projector.
Reset All
Settings
Returns all settings to the factory preset values.
The following settings will still remain: Position, Phase, H. Size,
Projector Installation, Language, High Altitude Mode, Security
Settings, Baud Rate.
FUNCTION DESCRIPTION