User`s guide

%**0
%**0%**0
%**0
2.3. Connecting the power
Connect the output end of the power cord to the power connector on the
rear panel of the unit. Then connect the power cord to the power outlet.
The green Power LED on the front panel should be lit.
2.4. Fiber Module Installation (Optional)
The fiber module is not included in the package, it’s optional. You can
choose to purchase the fiber module for your switch. The fiber module shall
be inserted into the expansion slot located at the rear of the switch.
• Remove the module from the static free container
• Set Full Duplex or Half Duplex operation mode by using J2 jumper
Full Duplex
Half Duplex
Figure 1. Full Duplex or Half Duplex setting