User`s guide

 2*+,-
 2*+,- 2*+,-
 2*+,-
Select (Y)es to reset VLAN group. At this time, no ports belong to any
VLAN groups and therefore user should note that traffic between ports is
disabled. In a word, the switch is disabled. After making decision about reset
VLAN, user can set the VLAN groups or toggle between VLAN pages, i.e.
page1~4, to check all 24 VLAN groups' status. For example, user chooses to
see VLAN page3 after reset VLAN groups; refer to the following figure.
2. Select Vlan page number to see each VLAN groups' members. In each
page, 6 VLAN groups' members are shown. For example, in the figure
below it shows that port 1, 2, 5, 6 are the only members of VLAN group
V08, and port 14, 15, F1, F2 are members of VLAN group V12.
3. Press[S] to set VLAN group. Select Group then choose port to join or
leave the VLAN group. For example, if port 1 wants to leave VLAN
group3, only select VLAN group3 and then choose port 1 to leave. As
that port 1 will leave V03 and the updated VLAN group status will be
shown on the screen.
4. To move back to the main menu, press [ESC] to exit the VLAN submenu.