User manual

38
Using the projector
English
Setting up the Wired LAN
1. Press MENU/EXIT and then press / until the System Setup: Advanced menu is highlighted.
2. Press to highlight Serial Port Setting and press ENTER. The Serial Port Setting page is
displayed.
3. Press to highlight Channel and press ENTER. The Channel page is displayed.
4. Press to highlight Wired LAN and press ENTER.
5. Press MENU/EXIT to return to System Setup: Advanced page.
Configuring the Wired LAN
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end
to the RJ45 port.
When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or
interruption.
2. Press MENU/EXIT and then press / until the System Setup: Advanced menu is highlighted.
3. Press to highlight Network Settings and press ENTER. The Network Settings page is
displayed.
4. Press to highlight Wired LAN and press ENTER. The Wired LAN page is displayed.
5. Press to highlight DHCP and press / to select On.
6. Press to highlight Apply and press ENTER.
7. Go back to System Setup: Advanced > Network Settings page.
8. Press to highlight AMX Device Discovery and press / to select On or Off. When AMX
Device Discovery is On, the projector can be detected by AMX controller.
9. Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN page.
10. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings will be
displayed. Note down the IP address displayed in the Projector IP Address row.
If the Projector IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press to highlight DHCP and press / to select Off.
3. Contact your ITS administrator for information on the Projector IP Address, Subnet Mask,
Default Gateway, and DNS Server settings.
4. Press to select the item you want to modify and press ENTER.
5. Press / to move the cursor and then press / to enter the value.
6. To save the setting, press ENTER. If you do not want to save the setting, press MENU/EXIT.
7. Press MENU/EXIT to return to Network Settings page, press to highlight AMX Device
Discovery and press / to select On or Off.
8. Press MENU/EXIT to exit the menu.