User manual

48
Using the projector
English
Note that the menu items are available when the projector detects at least one valid signal. If there is no
equipment connected to the projector or no signal detected, limited menu items are accessible.
System
Setup:
Advanced
Expert Mode
Expert Mode On/Off
Mode Selection Expert Mode 1/Expert Mode 2
Picture Adjustment
Brightness 0 ~ 100
Contrast 0 ~ 100
Color 0 ~ 100
Tint 0 ~ 100
Sharpness 0 ~ 15
Color Temperature
Expert 1/Expert2/Cool/Normal/Warm/
Lamp Native
White Balance
Red Gain (0 ~ 100)
Green Gain (0 ~ 100)
Blue Gain (0 ~ 100)
Red Offset (0 ~ 511)
Green Offset (0 ~ 511)
Blue Offset (0 ~ 511)
Copy Normal White Balance Value
(Apply / Cancel)
Blue Image On/Off
Gamma Selection 1.6/1.8/2.0/2.2/2.4/2.5/2.6/2.8/BenQ
System Setup
Brilliant Color On/Off
Black Level 0 IRE / 7.5 IRE
Noise Reduction 0 ~ 31
CCA
Primary Color
Desired R/ Desired G/ Desired B/
Desired C/ Desired M/ Desired Y/
Desired W/ Measured R/ Measured G/
Measured B/ Measured W/ Measured
BC1/ Measured BC2
x-Coordinate 0 ~ 999
y-Coordinate 0 ~ 999
Gain or Luminance 0 ~ 1999
Apply CCA Table
Lamp Wave Form
Reset Expert Mode
Expert Mode 1
Expert Mode 2
Reset All Settings Reset / Cancel
Information
Source
Picture Mode
Lamp Mode
Resolution
3D Format
Color System
Lamp 1 Usage Time
Lamp 2 Usage Time
Firmware Version