User Manual
Table Of Contents
- Copyright
- Disclaimer
- Power Safety
- Getting started
- Getting to know your monitor
- How to assemble your monitor hardware
- Getting the most from your BenQ monitor
- How to adjust your monitor
- The control panel
- Basic menu operation
- Controlling the display with Display Pilot (XL2411 only)
- Initial setup for playing games
- Picture optimization (XL2411 only)
- Customizing the hot keys
- Setting up your own game mode
- Downloading more game modes using Game Mode Loader (XL2411 only)
- Adjusting display mode
- Using Smart Scaling
- Using Instant Mode
- Navigating the main menu
- Troubleshooting
12 How to assemble your monitor hardware
2. Connect the PC video cable.
Do not use both DVI-D cable and D-Sub cable on the same
PC. The only case in which both cables can be used is if they
are connected to two different PCs with appropriate video
systems.
To Connect the D-Sub Cable
Connect the plug of the D-Sub cable (at the end
without the ferrite filter) to the monitor video
socket. Connect the other end of the cable (at the
end with the ferrite filter) to the computer video
socket.
Tighten all finger screws to prevent the plugs from
accidently falling out during use.
To Connect the DVI-D Dual Link Cable
Connect the plug of the DVI-D Dual Link cable to
the monitor video socket. Connect the other end of
the cable (at the end with the ferrite filter) to the
computer video socket.
Tighten all finger screws to prevent the plugs from
accidently falling out during use.
To Connect the DP Cable
Connect the plug of the DP cable to the monitor
video socket. Connect the other end of the cable to
the computer video socket.
Or
Either
Or