User's Manual

Note
1.This low-power RF motor is a certified and gualified product.
Companies, businesses or individuals may not change the frequency,
enhance the power or change the characteristics and functions of the
original design without permission.
2.Low-frequency RF motors should not affect flight safety and interfere
with legitimate communication when they are used. When interference is
found, they should be stopped using immediately and be improved to no
interference before they can continue to be used. Legitimate
communication refers to wireless communication in the work prescribed
by law. Low-frequency RF motors must be able to tolerate the
interference of legitimate communication or electromagnetic radiation
motor equipment for industrial, scientific and medical purposes.
3.This product contains miniature batteries for mainboard CMOS, which
cannot be replaced by consumers themselves. It may be dangerous if
consumers replace incorrect types of batteries by themselves. Please
properly handle the battery replacement.
Attention
1. This product is suitable for places below 3000 meters above sea
level; this product is only suitable for non-tropical areas.
2. Be very careful when performing operations that may cause damage
or loss of files.
3. After abnormal withdrawal or accidental power failure of the mini pc
system, the hard disk scanning should be carried out as soon as
possible to repair the errors in time.
4. When the mini pc boots, we should pay attention to the defense of the
virus and try to use the virus firewall.
5. Turn on the display, printer, and other peripherals first, and finally turn
on the device. Turn off the device first, then turn off the display.
6. If you do not use the device for a long time, turn off the main power
switch.
7.The ideal working temperature of the device is 10-35 degrees, and the
relative humidity is 30-80%.
8.The device should not be powered off for a long time (e.g.1-3 months)
before using it.
9. The device should not be turned on or off frequently;the time interval
between two boots should be at least 10 seconds, preferably no less
than 60 seconds.
10. You can't move the device or turn off the power while reading/writing
to the hard disk. Wait for about 30 seconds after shutting down it.
11. Pay attention to dust control, keep the environment clean and
hygienic, and wipe it with a dry soft cloth.
12.Avoid direct exposure of strong light to the device, and do not put it
near the strong magnetic field.
13. Don't get water, food and other fluids onto the device, and don't pull
the data and power lines with force.
Customer Service
For more information,
please scan QR code
www.benss-tech.com
[e-mail]
9
10
11