Manualshelf

User's Guide

ManualsBrandsBently Nevada ManualsElectronicsWireless Condition Monitoring Sensor
21222324252627282930
Table Of Contents
WirelessHARTSleepState
The WirelessHART device radio listens for advertisements from the configured network for a one-
hour period at periodic intervals. This is followed by a one-hour deep sleep period, after which
the device reinitiates searching for the network as it did during the first hour. This cycle continues
until it successfully joins the network or is rebooted.
Provision Using the Yokogawa ISA100 Gateway
Before you can provision Ranger Pro devices on a Yokogawa gateway, you must first add the
devices to the network configuration.
For more information and detailed instructions, refer to the Yokogawa documentation.
Add Devices
To add devices to a Yokogawa ISA100 network:
1. In the Yokogawa Field Wireless Management Console, open Configurator.
2. Add Ranger Pro devices to the Field Wireless Network on the Field Devices tab.
a. Set the Device Tag.
b. Check OTA Provisioning.
c. Select the Device Role as IO, IO Auto, or IO+Router.
d. (If applicable)Select the Primary Router.
e. (If applicable)Select the Secondary Router.
3. Click Download to apply the updated configuration to the gateway. When successful, a
confirmation message is displayed.
Apply capabilities file
After you add the devices, provision the devices. We recommend configuring the device
Sampling Data before provisioning devices. The capabilities file (CF) required to configure
devices is available from Bently Nevada Technical Support.
To apply a CFfile to the Ranger Pro devices:
1. In the Yokogawa Field Wireless Management Console, open Configurator.
2. Select Sampling Data. The Sampling Data pane is displayed.
3. Click Add. The Sampling Settings dialog box is displayed.
4. In the Device Tag field, click browse and select the check box of the device you want to
modify. You can select multiple devices of the same type. Click OK.
5. In the CF / DD pane, select CFFile. If the CFfile is not yet displayed:
a. Select Load CF/DD. TheWindows Open dialog box is displayed.
21/57
Ranger Pro Wireless Condition Monitoring Device
User Guide 125M6113 Rev. F