Operation Manual

Setting up
The indicator light ashes green shortly and the TV is ready to be used. To reduce start up time, see the online guide regarding
power settings.
The TV is in standby but leave it connected to the mains supply due to software downloads.
The TV has been disconnected from the mains supply and you must enter the pin code. See the online guide for more
information on the pin code system, available on www.beoplay.com/v1/support.
Do not disconnect the TV from the mains supply. Could be due to new software being activated or too many failed pin code
attempts.
The TV is in standby and you can disconnect it from the mains supply if you want. However, this activates the pin code system.
Indicator light – Green
Solid red
Slowly ashing red
Quickly ashing red
Off
You can fasten the cables to either sides or in
the middle, depending on stand or wall bracket
placement. For safety reasons, secure the cables
with the enclosed cable ties.
When you have made all the connections, mount
the connection cover.
6.Run cables
If you have a wall bracket, make sure that there is
enough slack in the cables to allow the TV to turn
before you fasten the cables with cable ties to
make a neat bundle.
Follow on-screen instructions. When available, press the blue button
for help texts.
MENU LANGUAGE
SOFTWARE UPDATE (USB)
COUNTRY
NETWORK SETTINGS
SOFTWARE UPDATE (INTERNET)
SPEAKER SETUP
SOURCE LIST SETUP
NICE TO KNOW
4.First-time setup
You will be guided through a number of menus
where you must make different settings. Use the
Beo4 navigation button , , and , and press
in the middle to select settings. In some submenus,
press BACK to return to rst-time setup.
You can change the settings again later if you
wish. If you receive your TV signal via a set-top
box, select DONE in SOURCE LIST SETUP. Set up
your set-top box as illustrated below.
The illustration here is only one example of many
possible setups.
When you connect external equipment, for example
a set-top box, to the HDMI IN socket on the
television (see next pages), you are prompted to
congure the source. Follow on-screen instructions.
For information on other setup options, PUC tables
and IR-transmitters, see the online guide available
on www.beoplay.com/v1/support.
5.Connect external equipment
For information on your Beo4 remote control, see page12 or your Beo4 guide.
TV
BACK
7
INTERNET
PUCHDMI
ETHERNET
It is possible to control non-Bang&
Olufsen equipment using the Beo4
remote control with Peripheral Unit
Controller (PUC) table. For PUC to
work, an IR-transmitter has to be
placed close to the IR-receiver on
the connected equipment. Check
the IR-signal before attaching the
IR-transmitter.
Indicator light