Instruction Manual

• The elevation is adjusted by turning the Front Sight Post itself.

It is also click-adjustable. Use the supplied tool to adjust the

elevation (Fig. 17).

• By turning the post clockwise the point of impact moves

down, by turning it counter-clockwise it moves up. That

means if your firearm shoots too high you have to turn the

post counter-clockwise. In case the firearm shoots too low,

you need to turn it clockwise.

SETTING THE RETRACTABLE STOCK

The retractable stock can be folded flush with the right side of

the gun. It is telescopic and adjustable in four positions. The

stock is fastened with a hinge on the right side of the stock

carrier and with a corresponding hinge on the right side of the

upper receiver (Fig. 9).

The stock carrier pin connects the receiver with the stock

carrier and allows the operator to rotate the stock 180°.

Pulling the buttstock latch allows the buttstock to be adjusted

to various lengths (Fig.18 and 19).

MOUNTING AN OPTICAL SIGHT

WARNING: Always be certain that the firearm is unloaded and

the chamber loaded indicator installed.

Please refer to the instructions given in the ”Load Check”

portion of this manual.

The gun is equipped with Picatinny rails following MIL-STD

1913.

These rails allow the installation of various accessories, like

aiming devices, laser sights, lights, bipods and others. The

upper and lower rails are numbered from rear to the front. If

accessories are removed, the numbering system ensures that

they can be remounted in the same position, which reduces the

need for resighting of aiming devices.

To mount an aiming device or optical sight, first fold down the

flip-up rear and front sights (Fig. 20 and 21).