Instruction Manual

31
Next, follow the accessory manufacturer’s instructions to attach
the accessory to the rail.
REVERSING THE BOLT HANDLE
WARNING: Always be certain that the firearm is unloaded and
the empty chamber indicator installed.
Please refer to the instructions given in the ”Load Check”
portion of this manual.
The bolt handle can be attached on either side of the bolt.
To move the bolt handle from one side to the other there must
be no tension on the mainspring because a locking mechanism
will hold the handle in position.
To take tension off of the main spring disassemble the gun (as
explained in the previous section) to the point where the guide
rod block comes out of the receiver.
Then extract the bolt handle from the bolt and attach it on the
other side (Fig. 22 and 23).
After reassembly, the locking mechanism will again hold the
bolt handle in position.
MAINTENANCE
The firearm should be cleaned as soon as possible after firing.
Use only high-quality, commercially-available firearm cleaning
solvents and cleaning equipment.
WARNING: The firearm should not be disassembled for
cleaning beyond what is described below. Only qualified
personnel (for example, gunsmiths) who are familiar with these
firearms should conduct further disassembly.
WARNING: Do not attempt to make repairs to any firearm
without proper knowledge or training. Do not alter parts or use
substitute parts not made by Beretta. Any alterations or