User manual

(GB) Installation and operating instructions LED

Rotating beacon for fixed installation

Art.-No. 20199

IMPORTANT: You require a special permit according to STVZO

§52 to operate the rotating beacon. Please inquire at your road

approval office (traffic authority)

You require a standard base to install the LED-rotating beacon. The

standard bases of the 'old' rotating beacons without LED techno-

logy also fit.

1. Screw the standard base in a suitable position onto the vehicle roof, so that the

rotating beacon can be seen from all sides.

2. Open the clamping screw at the RB and push the standard base into the holder

3. Tighten the clamping screw.

The LED-rotating beacon has 3 possible functions that can be set using the small, red

switch after removing the lamp glass

1. Rotating light

2. Double flash

3. Triple flash

The lamp glass is opened by turning it slightly to the left and is closed by turning it slightly

to the right (bayonet catch).

Technical data:

Voltage: 12/24 Volt

Number of LEDs: 80 units SMD

Operating modes: Rotating light – flashing light 2-times - flashing light 3-times

Measurements: Height 23 cm, lamp glass diameter- 12 cm,

Height of lamp glass 14 cm

Weight: 400 grams

Operating temperature: -30°C to +50 °C

E- test number E13 10R – 0412764 , Societé nationale de Certification et

d’homologation, L-5201 Sandweiler

Disposal:

Electronic devices are recycable materials and should not be disposed of with hou-

sehold waste. Dispose of the product at the end of its useful life according to the

applicable regulations.

www.berger-schroeter.de

also not permitted to reproduce extracts in any form that have been created or processed by use of electronic, mechanical or chemical

procedures. Technical changes can be made at any time without prior announcement. The operating instructions are corrected regu-

larly. We assume no liability for technical and typographical errors and their results.

20199_LED_Rundumkennleuchte_D/GB/F/NL 29.07.13 15:03 Seite 2