Owner`s manual

25 | P a g e
DC Terminal Connector
Figure 2.4
The Classic's DC terminal connector is located on the circuit board as shown in. The connector will
take up to a #4 AWG. #4 AWG THHN when installed in the Classic and MidNite E-Panel is rated for
over 100 amps and is therefore suitable for the highest power available from the Classic 150.
Over Current Protection and Wire Size Requirements
The over current devices, wiring, and installation methods used must conform to all electrical codes
applicable to the location of installation. Wiring needs to be protected with proper strain relief clamps
and or conduit. See page 75 for a breaker and wire size chart.
The network cables, USB cable, BTS cable and auxiliary input/output cables should run in a different
conduit to preserve their signal. When installing the Classic in a MidNite E-Panel, it is acceptable to
run all wiring through the same knockout hole. It is legal to run signal and power wires together as long
as all wiring is listed for the highest voltage to be encountered.
Current Rating
The Classic limits the output current based on the model you have.
The Classic current ratings are:
Classic 150 + 150 Lite - 96 amps maximum
Classic 200 + 200 Lite - 79 amps maximum
Classic 250 + 250 Lite - 62 amps maximum
Classic 250ks + 250ks Lite – 58 amps maximum