Owner`s manual

32 | P a g e
“Wizard” is highlighted. Scroll to the right until “Misc” is highlighted and press “Enter”. Now scroll to
“LED-Mode” and press “Enter”. Here you can use the up and down arrows to select the mode you prefer.
After selecting the appropriate LED Mode press “Enter” to save this data to the Classic. Pressing “Status”
will now bring you back to the home screen.
-OFF – No LED activity no matter what
-Rick Mode – LED Activity for Errors and Warnings only. (Over current, Arc Fault Etc)
-Blinky – basically cycles all the LEDs in a Disco fashion (Useful for Partys)
-LED 1 – LED activity for Warnings and Errors as well as info. A green LED on the display indicates the
Classic is in Float. A yellow LED on the display indicates a warning (Over Temp, over current etc). A red
LED on the Display indicates an Error (Arc Fault etc). There is also 3 LEDS inside the Classic that can be
viewed through the upper vents. The red LED indicates Auxiliary 1 is active. The blue LED is not used at
this time and the yellow LED indicates Auxiliary 2 is active
Calibrating Battery and PV Voltage
To calibrate the Classic battery and PV voltage reading, you will need a Volt meter to check the actual
battery bank voltage or input PV voltage. Using the volt meter measure the voltage on the DC terminal
connector of the Classic (refer to Figure 2.4) compare this reading to the reading on the Status screen in
the Classic,(press Status if not in this screen) to adjust the reading of the Classic to the one in the volt
meter follow these steps:
 Press Main Menu, scroll to TWEAKS and press Enter
 Highlight VBatt and use the up and down arrow keys to match both of the readings
 Press the Enter button to save
Note. Use the description below to help complete the calibration of the Classic voltages.
TWEAKS screen
Figure 2.7
Configuring DC Input Source
To select the Mode the Classic will run in, follow the steps below.
 Push the Main Menu button.
 Scroll left or right until Mode is highlighted and then push the Enter button.
 Scroll to the right and highlight the current Mode than use the up and down arrows to set the
mode you want.
 Take note of the Right soft key most modes have some set points that can be adjusted.
 Press the Main Menu button until you get back to the Mode Menu
 Set the ON/OFF to ON and press Enter
Battery voltage adjust
Battery voltage
offset
Displayed
battery voltage
Input voltage adjust
Input voltage
offset
Displayed Input
voltage