Owner`s manual

35 | P a g e
Setting the Date and Time
To set the date and time manually on the Classic follow the steps below.
 Push the Main Menu button repeatedly until Wizard is highlighted.
 Scroll left or right to highlight “MISC” and push the Enter button
 Scroll to “Time” and push Enter
Now scroll left or right to highlight the data you want to manually change. Use the up and down buttons
to change the data. When you have all the data changed push the Enter button to save the changes.
The Classic includes a battery in the MNGP portion, to keep the time running even when the power is
disconnected. To replace the battery refer to the Installation Manual
Setting Longitude and Latitude
With the built in virtual map, you are able to select where you are in the world. For a more precise setting
you can manually enter the longitude and latitude coordinates, geographic location is important because it
helps determine when the Classic wakes up and when it goes to sleep. This setting tells the Classic when
sunrise and sunset are to happen. The Classic will use this information on future features also. To set
longitude and latitude coordinates you need to go thought the WIZARD that is the only way to gain
access of this feature
Configuring Auxiliary Input/Output
The Classic includes two auxiliary ports which can be configured to become inputs or outputs. These aux
ports can be used as a secondary power supply to be used for accessories such as vent-fan, anemometer
and generator starter or even and anemometer. The Aux output is limited to 200ma or less per channel.
These aux ports if used correctly could extend the system life. Here is an explanation of how they work.
 An internal, re-settable Positive Temperature Co-efficient (PTC) fuse protects the AUX internal
components from overcurrent or a short circuit.
 AUX 1 consists of either RELAY or LOGIC operation depending on the user selection function.
 AUX 2 could be set to become an INPUT or OUTPUT. One at a time this port could be reading
the state of a device connected and takes an action from there.
To configure the Classic's Aux ports:
 Push the Main Menu button
 Scroll left or right to highlight “AUX” and push the Enter button.
Scroll left or right to highlight the relay you wish to change. Push the right soft key labeled “SETUP”.
Scroll up or down to change the function of the relay. Select the right soft key to set the parameters of the
function. When finished push the ENTER button to save the changes.