Owner`s manual

54 | P a g e
Section 2 Switch settings explained
DHCP or Static IP address Switch 1 (Section 2)
On Section 2, Switch 1 when on will enable DHCP. This will allow the Router on the network to assign the Classic
Lite an IP address. When off it sets the Classic to a static IP address that will be determined by Switches 2, 3 and 4.
IP Address Switches 2, 3 and 4 (Section 2)
On Section 2, Switches 2, 3 and 4 will set the Static IP Address of the Classic Lite to the address shown in the table
below if Switch 1 is set to Off for Static IP.
ModBus Port Switches 5, 6 and 7 (Section 2)
On Section 2, Switches 5, 6 and 7 set the ModBus port of the Classic Lite. The values that correspond to the
switches are found in the table below.
The actual Labels that are on the inside of the MNLP.