Model FMS30 Model FMS40 ML-134462 ML-134463 ML-134476 ML-134477 ML-141002 OWNER/OPERATOR MANUAL Berkel Company PO Box 696 2006 Northwestern Parkway Louisville, Kentucky 40201 1-800-348-0251 Fax 888-888-2838 F37236 Rev.
TABLE OF CONTENTS GENERAL .......................................................................................................................... 3 INSTALLATION .................................................................................................................. 3 Unpacking .................................................................................................................... 3 Location ............................................................................................
Installation, Operation, and Care of BERKEL FMS30 & FMS40 Quart MIXER SAVE THESE INSTRUCTIONS GENERAL The 30 quart mixer has an AC Induction electric motor and motor control. A 30 quart bowl, B-Flat beater, spiral dough hook, D wire whip and ingredient chute are shipped as standard equipment. A 0 - 15 minute timer and four plastic foot pads are standard. A #12 attachment hub is standard. A variety of attachments are available. A 20 quart bowl and it's associated accessories are optional.
ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS (CORD CONNECTED MIXERS) Single-Phase Mixer The electrical cord on this machine is equipped with a three-pronged grounding plug which must be connected to a properly grounded receptacle. If the receptacle is not the proper grounding type, contact an electrician. Do not remove the grounding prong from the plug.
OPERATION Moving beater in bowl. Keep hands, clothing, and utensils out while in operation. Do not use without interlocked guard. Controls Attachment Hub Thumb Screw and Plug Bowl Guard/ Splash Guard Bowl Guard/ Wire Cage Bowl Lift Handle Agitator Bowl Support Fig.
CONTROLS (FIG. 2) Speed Selector Starts Mixer Time Selector Stops Mixer Fig. 2 Push-button Start and Stop buttons control power to the mixer. The Bowl Guard /wire cage must be in place and closed or the mixer will not operate. If the Bowl Support is not all the way up, the mixer will not operate. The TIMER is used in conjunction with the Start button for timed mixing operations and will stop the mixer when the desired time has elapsed.
MIXING This section explains operation of the mixer and how to install bowls and agitators. BOWL New mixer bowls and agitators (beaters, whips, spiral dough hook, ingredient chute and splash cover) should be thoroughly washed with hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and Fig. 3 thoroughly rinsed with clear water before being put into service. This cleaning procedure should also be followed for bowls and agitators before whipping egg whites or whole eggs.
BOWL GUARD / WIRE CAGE Wire cage must be in position and closed in order to mix. If wire cage is opened during the mixing, mixer will stop. REMOVE BOWL GUARD / WIRE CAGE Lower the bowl support and remove agitator before removing bowl guard/wire cage. Hold wire cage with both hands and pull downward gently to release from retainer (Fig. 5). INSTALL BOWL GUARD / WIRE CAGE Hold wire cage with both hands and gently push upward until bowl guard/wire cage is latched on the retainer and can be rotated freely (Fig.
MIXING BOWL CAPACITY CHART Capacity of Bowl (Qts. Liquid) Model Motor (HP) Overall Space Required (Bench Space) Agitators Suitable for Operation 30 Quart FMS30 2.0 40 Quart FMS40 2.5 21 ½" W X 26¼" D X 45"H 21 ½" W X 26 ¼"D X 48" H Kitchen Materials Capacity Chart (Finished Materials) Egg Whites (pt.) Mashed Potatoes (lbs.) Mayonnaise (Qts. of Oil) Meringue (Qty. of Water) Waffle or Hot Cake Batter (qt.) Whipped Cream (qt.) D B B or D D B D 3 pts. 23 lbs. 12 qts. 2 pts. 12 qts. 6 qts. 3 ½ pts.
AGITATORS AND ACCESSORIES B Flat Beater D Wire Whip Spiral Dough Hook Ingredient Chute Splash Cover MAINTENANCE Disconnect electrical power before beginning any maintenance procedure. MOTOR The motor has sealed ball bearings which require no lubrication maintenance. BOWL LIFT SLIDEWAYS The bowl lift slideways (Fig. 6) should be lubricated once each month. Apply a light coat of a "Food Grade" grease to both sides of the slideways. Slideway Fig.
SERVICE AND PARTS INFORMATION To obtain service and parts information concerning the FMS30 & FMS40, you have two options: 1. You can contact the local Designated Berkel Service Location (DBSL). To locate the nearest DBSL, please visit www.berkel.com. Additional information may be obtained by dialing (800348-0251). 2. You can contact the local Hobart office in your area, or call 1-888-4HOBART. You can also find the nearest Hobart office by visiting www.hobartservice.com.
Warranty Effective: February 14, 2002 Berkel Company (''Berkel") warrants to the Buyer of new equipment that said equipment, when installed in accordance with our instructions and subjected to normal use, is free from defects in material or workmanship for a period of one (1) year from the date of sale.1 BERKEL SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTABILITY OR EXPRESS OR IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE.
