Instructions / Assembly

B. Remove the hex nut (15) and the spigot from the inside of

the lower chamber (11) and screw the hex nut back onto the

spigot (12) with the washers (13, 14) attached.

C. Leave the rubber base ring (16) attached to the bottom of the

lower chamber (11).

D. Set all pieces aside.

A. Place the purification elements (6), which have been allowed

to dry for 24 hours, in a re-sealable zipper storage bag. Then

place them in their original box. Place the optional PF-2

elements (10) in a re-sealable zipper storage bag as well.

B. Bag all parts, such as the knob (1), spigot (12), and hole

plugs (9), in their original bag or in a re-sealable zipper

storage bag.

C. Take the upper chamber (5) and set it upright.

D. Place the filtration elements and the parts inside the upper

chamber (5). Please add packing material to the inside of the

upper chamber to properly secure all items.

E. Turn the lower chamber (11) upside down and place it over

the upper chamber (5). It should fit over the outside of the

upper chamber. The lower chamber will stop before touching

the rim of the upper chamber.

F. Flip the entire system so that the rubber base ring (16) is on

the bottom and the bottom of the upper chamber (5) is facing

up (the bottom of the upper chamber has the holes for the

purification elements.)

G. Place the lid (2) on the bottom of the upper chamber (5).

H. Place the system inside the original product box if available,

and seal it with tape for shipping. Do not apply the shipping

label directly onto the product box. Instead, please place the

product box, along with sufficient packing material, into

another larger box for shipping.

Please return the Berkey® system to:

James Enterprise Inc. / Berkey Filters

1976 Aspen Circle

Pueblo, CO 81006

Step 4 – Packing the System for Return Shipping

Failure to properly pack your system for return shipping could result in a restocking handling fee of

up to 20% if the unit is received damaged.