User's Manual

Cleaning the Micro and Power Mold

Clean your Micro/Power Mold after every use by

wiping it with a clean dry cloth. In most cases,

there is a hole through the Micro/Power Mold

(below the speaker unit). This is the vent. If the

vent is plugged with wax, insert the cleaning tool

(supplied) from the opposite end (nearest the

speaker wire), and push through to remove the

wax.

Replace the wax protection (WaxStop)

whenever needed following this procedure:

1) Take the stick with the new WaxStop on it (1).

On the opposite end is a removal plug for the

used WaxStop (2).