Instruction manual
130
Preparing for embroidery
Embroidery hoop
Center determination
⦁
determine the location of the center of the design within the fabric
⦁
mark the material with fabric marker or chalk
Using the embroidery hoop
⦁
loosen the screw 1 of the outer hoop if necessary
⦁
remove the inner hoop
Match the arrows 2 of both hoops.
The arrows are
̶ on the oval and medium hoop at the center front
̶ on the small hoop to the right side
̶ on the Mega Hoop and Jumbo-Hoop (optional accessory) at the center
front
Embroidery template
̶ there is an embroidery template for each hoop
̶ the embroidery area is marked in 1cm squares
̶ the center and end point are marked with holes
⦁
for transferring marks to the material
⦁
attach the embroidery template holder
⦁
place the template in the inner hoop, so the BERNINA logo is at the front
edge (by the arrows) and can be read
►
in this position the embroidery template clicks into the inner hoop
Hooping the material
⦁
place the material under the inner hoop
⦁
line up the marked center point on the center of the template
⦁
place the material and inner hoop on the outer hoop
Match the arrows of both hoops.
⦁
fit hoops into each other; ensure that the material does not
move
⦁
hoop the material to be embroidered tightly
⦁
tighten the screw
⦁
remove the template from the hoop by using the template holder
1
2
034247.71.04_2014-02_Manual_B750_EN