Operation Manual

14
Preparation - Sewing
Threading the Upper Thread
Attaching the thread spool
█
raise the needle and presser foot
█
power switch to «0» (off)
█
place foam pad on pin base
█
place spool on pin (thread unwinds clockwise)
█
attach appropriate spool disc - diameter of spool determines disc size, there
must be no clearance between the disc and the spool
█
take thread through rear guide A
█
then into slit of upper thread tension B
█
pull thread down to the right of the take-up cover and around C
█
take thread up to the left of the cover and around D, placing it in the
take-up lever
█
take thread down and through guides E and F
Needle Threader
1 Press lever down
█
raise needle
█
lower the presser foot
█
hold thread to the left and back
█
press lever A down and simultaneously guide the thread around hook B to
the right to the needle
2 Guide thread to front of the needle
█
put the thread from the front into the guide C until it catches in the wire
hook
3 Release lever and thread
█
release lever A and thread
█
put the thread under the foot and pull the thread backwards or
█
put the thread under the foot and pull it from front to back over the thread
cutter on left side of the head frame
B
A
A
1
3
B
A
C
D
E
F
C
2
033301.71.04_2014-02_Manual_B330_B350_PE_B380_EN