Operation Manual

31
Sewing stitches - Examples of application
Examples of Application
Zipper foot/sole No. 4
Straight Stitch
Preparation
█
baste seam closed and clean finish the seam allowance
█
baste or pin zipper in place so that fabric folded edges meet over the center
of the zipper
Sewing
█
open zipper a little
█
start sewing from top left
█
position the foot so the needle stitches along the edge of the zipper coils
█
stop in front of the pull (needle position down), raise the presser foot and
close zipper again
█
continue to sew to the base of the zipper (needle position down)
█
turn fabric and sew across the seam (needle position down)
█
turn fabric again and sew second side of the zipper from bottom to top
Variation: Sew both sides of zipper from bottom to top
█
suitable for all fabrics with nap or grain (e.g. velvet)
█
prepare zipper as described above
█
start sewing in the seam of the zipper end and sew first side from bottom to
top
█
sew the second side the same way from bottom to top
To sew around zipper pull
█
close the zipper and sew up to about 2” (5cm) away from the pull
█
stop with the needle down in the fabric, raise the presser foot.
Open zipper, pulling the tab below the needle; lower presser foot
and continue to sew
Seam begin
Hold thread firmly when starting to sew = pull fabric slightly to the
back (fewer stitches).
Zipper or fabric is thick or densely woven
For even stitch formation use a 90 -100 needle.
Zippers
033301.71.04_2014-02_Manual_B330_B350_PE_B380_EN