Manual and User Guide

25
FRIDGE
UNIT
9
CR
ISP
E
R
10 11 12
11 Display
13 Crisper
12 Up/Down
English
Shows the temperature of the Crisper-Fresco compartment.
Allows switching on and off of only the Crisper-Fresco compartment
(press
for three seconds).
Using the Up and Down buttons, it is possible to change the
temperature set for the Crisper-Fresco compartment.
8
1 Unit
2 Fridge
3 Menu
4
Up/down
Fridge
5 Display
6
Up/Down
Freezer
(TriMode)
7 Enter
8 Ice maker
9 Alarm
Switches the appliance (all compartments) between ON and STAND BY
(press for three seconds).
Allows switching on and off of only the refrigerator compartment
(press for three seconds).
Allows access to the appliance function menu
It shows the temperature of the refrigerator and freezer compartments,
the date and time, Menu functions and visual messages.
By selecting Up/Down the preset temperature can be changed accord-
ing to the selected function mode (freezer, refrigerator, Crisper-Fresco).
Confirms activation or deactivation of the selections made in the
Menu.
Allows activating or deactivating the automatic ice production.
Blinks to signal user alerts such as door left open, also in combination with
a sound signal which can be deactivated by pressing the button.
Using the Up and Down buttons, it is possible to change the set tempera-
ture of the refrigerator and navigate through the interactive menu.
1234 56798
I
CE
MA
K
E
R
E
N
T
E
R
FR
ID
GE
U
NI
T
Installation Guide
Series: All
EnglishFrançais
Start up
If at the rst start - up the message Stand by
does not appear, but other messages appear,
such as Fridge too warm, Fresco too warm,
Freezer too warm, or sound signals are activat-
ed, it means, it means that the appliance has
already started the cooling process.
If this is the case, deactivate any possible acous-
tic signals by pressing the Alarm button, close
the door and wait until the set temperature is
reached.
To start the appliance, connect the plug to the electrical mains: at
this point, when opening the door, the control panel will usually visual-
ize the message “Stand by”, and all the panel keys be off
To turn on all the appliance compartments, press the Unit button
for three seconds. The display will show the message “Initial test” for
approx. 2 minutes. After this phase the compressors will start up and re-
main on until the default temperature set up in the factory is reached.
Do bear in mind that this condition could last several hours during
which time the display will continue to ash the ‘Start Up Phase’ mes-
sage.
If the appliance is provided with an Ice Maker, prior to switching it on
make sure that the water lter cartridge is installed (unless water sup-
ply source is already ltered by other means such as reverse osmosis).
Purge air from the water lines by enacting the ‘Manual Clean’ func-
tion from the Menu->Functions->Water Filter options. You may need to
complete this sequence several times until you stop hearing air sput-
tering from the ice maker ll tube.
Once you are satised that the system is purged of air switch the Ice
Maker on by touching the button which will illuminate.
Note: If the TriMode drawer is congured as a Fridge or a Fresco com-
partment the ice maker will be disabled. Default mode for the TriMode
drawer is Freezer.
For further information about the appliance operation, refer to the
User Manual.
It is necessary to let the unit reach the correct
temperature before foods are stored inside.