Installation, Use and Care Manual

9
INSTALLINGTHEANTI‐TIPStabilityDEVICE
Theanti‐tipbracketshippedwiththerangemust
beproperly secured tothe rear wall as shown in
thepicturebelow.
Theheightofthebracketfromthefloormustbe
determined after the range legs have been
adjusted to the desired height and
 afterthe
rangehasbeenlevelled.
Measure the distance from the floor to the
bottom of the anti‐tip bracket receptacle on the
backoftheappliance.
Position the two anti‐tip brackets on the wall at
the desired height plus 1/8" (0.32  cm). The
bracketsmustbe placed  at
2”5/16(6,0cm)from
the side of the range. The distance between the
twobracketis25”1/4(64,1cm).
Secure the brackets to the wall with appropriate 
hardware.
Slidetherangeagainstthewall untilthebrackets
are fully inserted into their receptacles on the
backoftherange.



INSTALLATIONREQUIREMENTS

ELECTRICAL
A properly grounded and horizontally‐mounted 
electrical receptacle Type NEMA 14‐50R should
beinstallednohigherthan3"(7.6cm)abovethe
floor, no less than 2” (5 cm) and no more than
11” (28 cm) from the left side (facing product);
refer to ELECTRICAL CONNECTION section pag.
13.

Checkalllocalcoderequirements.

GAS
Anagency‐approved,properly‐sizedmanualshut‐
off valve should be installed no higher than 3"
(7.6 cm) above the floor and no less than 2” (5
cm)andnomorethan8”(20.3cm)fromtheright
side(facingproduct).
To connect gas
 between shut‐off valve and
regulator, use agency‐approved, properly sized
flexible or rigid pipe. Check all local code
requirements.

