Use & Care Manual

16
Error Codes
When some malfunctions come on, the appliance will display error codes to warn you:
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak, the water
should be removed before restarting the dishwasher.
WARNING
during the water inlet step, if the flow meter
can't detect the defined water after 4
minutes, the dishwasher will warning for E1.
1. check the water supply
2. check the inlet valve
3. check the inlet
4. check the flowmetre
5. check the pressure switch
6. check the drain
7. check the PCB
(only appeared in the factory mode)
when the temperature cant reached the defined value
after 90 minutes, the dishwasher will warning for E3.
1. check the heater
2. check the thermistor
3. check the PCB
the water flood into the bottom and result in the
detective switch moves, the dishwasher will warning
for E4.
1. check the use of the detergent
2. check whether the appliance is level
3. check the micro-switch
4. check the drain pump
5. check the amount of the filled water
6. find where leakage is
(only appeared in the factory mode)
E6 - thermal sensor cut.
E7 - thermal sensor short.
1. check the inlet water temperature
2. check the thermistor
3. check the PCB
E1
E3
E4
E6
E7
E9
Ed
If pushing one buttom for more than 30s, the
dishwasher will warning for E9
Buttom sticks,warning resovlved when
releasing the buttom
If the Dashboard detect communication data is
abnormal for more than 30s, the dishwasher
will warning for Ed
communication data abnormal, warning
resovlved when communicate data return
to normal.