Dishwasher Use & Care Manual DW 24XT
Please kindly register on our web site www.bertazzoni.com to validate your new product warranty and help us to assist you better in case of any inconvenience. TWO YEAR LIMITED WARRANTY The warranties provided by Bertazzoni Spa in this statement apply exclusively to Bertazzoni appliances and accessories sold as new products to the original owner by a Bertazzoni authorized distributor, retailer, dealer or service center and installed in the United States and Canada.
WHAT IS NOT COVERED 1 The product used in any commercial application 2 Repair service provided by other than a Bertazzoni authorized service agency. 3 Damage or repair service to correct service provided by an unauthorized agency or the use of unauthorized parts. 4 Installation not in accordance with local electrical codes or plumbing codes. 5 Defects or damage due to improper storage of the product.
Table of Contents Important Safety InstructionS ...................... 1 Features of your new dishwasher...............2-4 Operating Instructions ........................... 5-10 Preparing and loading dishes ................ 11-13 Care & cleaning ................................... 14-16 Troubleshooting .................................. 17-18 Installation instructions .............................
Important safety instruction WARNING For When using your dishwasher, follow basic precautions, including the following: Proper installation Please install your dishwasher properly follow the installation guide. Water supply temperature should be 120 ℉or 149 ℉. Dispose of the discarded appliance and packing material properly. The dishwasher must be grounded, or it can result in a risk of electric shock. PERMANENTLY CONNECTED and CORD-CONNECTED are both allowed.
Features of your new dishwasher Specification Capacity 16 place settings (max) Dimension 606 x 623 x 857 mm (W x D x H) Weight unpacked 94lb (42.
Features of your new dishwasher Features Filter System Your dishwasher has a multiple Filte System .Inthe System there are four filter-meshes .It can separate soiled water and clean water in different chambers. The multiple filter system helps your dishwasher to get better performance with less water and less energy . Smart Wash System Your dishwasher has Smart Wash System. When apartial load of lightly soiled dishes is placed in theunit, a wash cycle similar to a short wash willautomatically be performed.
Features of your new dishwasher How your dishwasher cleans Getting Started Your dishwasher cleans by spraying a mixture ofhot water and detergent through the spray arms against soiled surfaces . 1.Load dishwasher (See preparing and loading dishes). The dishwasher fills with water covering the filterarea. Water is then pumped through the multiple filter and spray arms.Separated soil particles go down the drain as the water is pumped out and replaced with clean water.
Control panel 1 2 3 5 7 4 6 8 9 10 11 12 14 13 Wash Cycle Selections 1 Display Window To display the remained hours and minutes of the running cycle, delayhours and error codes etc. 2 CYCLES With the dishwasher door open,you can press the CYCLES button to select the wash cycle. A light onthe display will in dicate which cycle has been selected. 3 AUTO This cycle is sen sing wash,lightly,norm ally or heavily soiled crockery,with or without dried-on food.
Operating dishwasher Functions 16 17 18 15 16 SANITIZED indicator light If a cycle with the sanitize function is finished,the sanitized indicator light turns on. If you open the door, it will turn off after 30 seconds.another possible,it will turn off immediately if you haveany operation. 15 START CANCEL Open the door, select a wash cycle that you desired, the indicator light beside the pad will turn on.
Operating dishwasher Error indication Status Window H:01- H:24 If the Delay Start option is s elected, the number of delay start hours shows in the status window. In certain situations which are critical to the machines function and safe operation, the control shall shut down and indica te an errorcode (See Error Codes on page 18). 2:15-0 :00 After the m achine works, the remaining time of the cycle that have been selected will be showed in the Status Window.
Operating dishwasher Adjustable Upper Rack The upper rack height can be easily adjusted to accommodate loading taller dishes in either rack. To accommodate taller dishes in the bottom rack, thereare 2 positions available: 1. Lift the rack for upper position Upper rack The upper rack in the upper position Lower rack Dish Preparation 2. Up press the handle to lower the rack Scrape away large pieces of food,bones,pits, toothpicks,etc.
Operating dishwasher Loading the Upper Rack Make sure the loaded dishes do not interfere with the rotation of the middle spray arm, which is located at the bottom of the upper rack. (Check this by rotating the middle spray arm by hand.) The upper rack is designed for cups, glasses, small plates, bowls and plastic items marked safe etc. For best results, place the bowls, cups, glasses, sauce pans with soiled surface facing down or toward thecenter. Tilt slightly for better drainage.
Cutlery Rack 8 place settings Upper Rack 8 place settings Bottom Rack 8 place settings Cutlery Rack 12 place settings Upper Rack 12place settings Bottom Rack 12 place settings Cutlery Rack 14 place settings Upper Rack 14place settings Bottom Rack 14 place settings Cutlery Rack 16 place settings Upper Rack 16place settings 10 Bottom Rack 16 place settings
Preparing and loading dishes Loading the Silverware Basket Adding A Dish The silverware basket could be divided into three separate modules that can be used in both upper and lower racks To add or remove items after wash cycle starts: 1. Open door slightly and wait a few seconds until wash action stops before completely opening. 1.Spoons 2.Knives 3.Salad forks 4.Forks 5.Large spoons 6. Large forks 2.Add the item. 3.Press the S tart/C an cel 4.
Preparing and loading dishes Filling the rinse aid dispenser Your dishwasher ids esigned to use a liquid rinse aid. The use of rinse greatly improves drying performance after the final rinse.Do not use a solid or bar-type rinse aid. Under normal conditions, the rinse aid will last approximately one month, try to keep it full, but do not over fill. 1.Open the door,turn the dispenser cap to left and lift it out. 3.
Preparing and loading dishes 1. Push the dispenser cover latch down wards and open it The amount of the detergent needed depends on the cycle and soil level of dishes, refer to the table below and adjust the recommended amount as necessary for your load.
Care & cleaning Cleaning the exterior door and panel 2.Control panel 1. Stainless steel panel Clean the stainless steel door and handle regularly to remove the debris with cleaning soft cloth. Do not use appliance wax, polish, bleach or products containing chlorine to clean the stainless steel door. Clean th e co ntrol panel with a light ly dampen ed cloth, clean it generaltly. Clean the Stainless Steel Inner Door and Tub Clean the spots on the steel inner door and tub with a damp nonabrasive cloth.
Care & cleaning Clean the Fine Filter Take out the Cylinder Filter and remove the Fine Filter from the dishwasher tub bottom. To rem ove the Fine Filter you m ust first re m ove the bottom spray arm as shown below. Flush the Fine Filter by holding it under running water and replace.
Care & cleaning Clean the door gasket Air gap Clean the door gasket with a damp cloth to removefood particles regularly. If there i s an air gap insta lled with your dishwasher,make sure it is clean so the dishwasher will drain properly. Air gap is not part of your dishwasher. Before you clean the air gap,turn off the dishwasher firstly and lift off the cover Remove the plastic cap and clean with a toothpick.
Troubleshooting Clean the door gasket Problem Possible cause Power supply or power line is not connected Shut the door completely make sure it is latched Check and connect the power supply Delay Start option has been selected Refer to Delay Start section in this manual to rese Child Lock activated (selected models) Deactivate the child lock, refer to child lock section in this manual Dishwasher won't start Dishwasher won't start Dishwasher beeps at the end of the cycle It indicates the wash cycle
Troubleshooting Problem Possible cause Detergent may be too old Detergent left in dispenser cup Use fresh detergent Spray arm is blocked Load the dishes,making sure the spray arms are not blocked.
Error Codes When some malfunctions come on, the appliance will display error codes to warn you: Codes Meanings Possible Causes E1 Longer inlet time. Faucets is not opened, or water intake is restricted,or water pressure is too low. E4 Overflow. Some element of dishwasher leaks . Ed signal responsion abnormal( happens when the problem lasts more than 20s, hint but not warning). Signal error E8 Failure of orientation of distributary valve. Open circuit or break of distributary valve.