Operating Instructions and Installation Instructions

7
ATTENTION: The appliance conforms with the regulations of directives
90/396EEC (Gas Directive) regarding gas appliances for domestic use and the
like, 73/23 (Low Voltage Directive) regarding electrical safety and 2004/108/CE,
(EMC Directive) regarding electromagnetic compatibility.
Ensure that the electricity supply is switched off before making the connection. This
appliance must be earthed.
Connection to the electricity supply must be made through the flex cable that is
already attached to the rear of the cooker. The end of the cable is tucked into the
cooker storage area.
Connection to the supply must be made through fixed wiring. It cannot be connected
to a normal domestic power socket. A double pole switched cooker box should be
used with contact separation of at least 3mm.
Turn on each hob zone to check that all elements are functioning correctly. Remove
all packaging and combustible items from the oven. Turn on the oven selector switch
and thermostat knob to check that the oven is functional on all modes.
Adaptation to different Before performing any maintenance operation, disconnect the appliance from
types of gas
the gas supply and electricity network.
Replacing the gas nozzles to operate with another type of gas:
Follow the instructions below to change the burner nozzles on the work
surface:
- Isolate the appliance from the electric outlet to avoid any type of electric contact.
- Remove the grids from the work surface.
- Remove the burners.
- Unscrew the nozzles using a 7 mm spanner, and replace them (Fig.4) with those
needed for the new type of gas according.
Fig 4
Follow the instructions below to change the oven burner nozzle (model 90x60
single oven):
- Remove the oven level (Fig.5).
- Loosen the screw V and pull out the burner from the support being careful not to
damage the ignition plug and the thermocouple (Fig. 6).
- Unscrew the nozzle R using a 10 mm spanner and replace it with the nozzle
needed for the new type of gas according.
Fig 5 Fig 6
Follow the instructions below to change the oven burner nozzle (model 60x60
single oven):
Remove the oven level (Fig.7).
- Loosen the screw V and pull out the burner from the support being careful not to
damage the ignition plug and the thermocouple (Fig.7).