BERTAZZONI INSTALLATION MANUAL FREESTANDING FULL GAS RANGES 3070290 WWW.BERTAZZONI.
/ Table of contents TABLE OF CONTENTS WARNINGS ___________________________________________________________________ DATA RATING LABEL ___________________________________________________________ BEFORE INSTALLATION ________________________________________________________ VENTILATION PREPARATION ____________________________________________________ SPECIFICATIONS ______________________________________________________________ CLEARENCE DIMENSIONS ______________________________________________________ INSTALLATI
/ Models Models Models MAST304GASXV PROF304GASART MAST304GASXVLP PROF304GASBIT MAST305GASBIE PROF304GASGIT MAST305GASNEE PROF304GASNET MAST305GASXE PROF304GASROT MAST305GASXELP PROF304GASXT MAST365GASBIE PROF304GASXTLP MAST365GASNEE PROF366GASART MAST365GASXE PROF366GASBIT MAST365GASXELP PROF366GASGIT MAST366GASXT PROF366GASNET MAST366GASXTLP PROF366GASROT MAST486GGASBIE PROF366GASXT MAST486GGASNEE PROF366GASXTLP MAST486GGASXE PROF486GGASART MAST486GGASXELP PROF486GGASBIT
/ Warnings WARNINGS To ensure proper and safe operation, the appliance must be properly installed and grounded by a qualified technician. DO NOT attempt to adjust, repair, service, or replace any part of your appliance unless it is specifically recommended in this manual. All other servicing should be referred to a qualified servicer. Have the installer show you the location of the gas shutoff valve and how to shut it off in an emergency.
/ Warnings Engage the range to the anti-tip device by anti-tip brackets or anti-tip chain (see installing the anti-tip device chapter). Ensure the anti-tip device is re-engaged when the range is moved. Re-engage the anti-tip device if the range is moved. Do not operate the range without te anti-tipdevice in place and engaged. See anti-tip device installation instructions for details. Failure to do so can result in death or serious burns to children or adults.
/ Data rating label / Before installation DATA RATING LABEL The data rating label shows the model and serial number of the range. It is located under the control panel and in the last page of this manual. A manual valve shall be installed in an accessible location in the gas line external to the appliance for the purpose of turning on or shutting off gas to the appliance. BEFORE INSTALLATION Type of gas • This appliance shall only be installed by an authorized professional.
/ Ventilation preparation / Specifications VENTILATION PREPARATION Hood Placement: This range will best perform when installed with Bertazzoni exhaust hoods. These hoods have been designed to work in conjunction with the Bertazzoni range and have the same finish for a perfect look. Before installation of the exhaust hood, consult local or regional building and installation codes for additional specific clearance requirements.
/ Specifications Burner Auxiliary Semi-rapid Rapid Dual burner MAIN oven 30’’/48’’ Broiler 30’’/48’’ Oven 36’’ Broiler 36’’ AUX. Oven 48’’ Injector Gas Pressure Max Rate diam.[mm] Type [iwc] [Btu/hr] [W] 0.90 0.54 1.18 0.70 1.55 0.92 0.80+2.10 0.50+1.20 1.85 1.10 1.40 0.98 2.00 1.16 1.60 0.98 1.25 0.
/ Clearence dimensions CLEARENCES DIMENSIONS Installation adjacent to kitchen cabinets This range may be installed directly adjacent to existing countertop high cabinets (36” or 91.5 cm from the floor). For the best look, the worktop should be level with the cabinet countertop. This can be accomplished by raising the unit using the adjustment spindles on the legs.
/ Installation requirements / Electrical connection INSTALLATION REQUIREMENTS ELECTRICAL A properly-grounded horizontally- mounted electrical receptacle should be installed no higher than 3” (7.6 cm) above the floor, no less than 2” (5 cm) and no more than 8” (20,3 cm) from the left side (facing product). Check all local code requirements. GAS An agency-approved, properly-sized manual shut-off valve should be installed no higher than 3” (7.
/ Wiring diagram WIRING DIAGRAM The electric wiring diagrams and schematics are attached behind the range, and should not be removed except by a service technician, then replaced after service. COLOURS MAGNET UNITS & TERMOCOUPLES Simb. J13 J12 J11J10 J9 J8 J7 n IGN T-Z bi J1 J2 J3 J4 J5 J6 G Comm.
/ Gas connection GAS CONNECTION Warning! FLEXIBLE CONNECTIONS DO NOT USE AN OPEN FLAME WHEN CHECKING FOR LEAKS! In case of installation with flexible couplings and/ or quick-disconnect fittings, the installer must use a heavy-duty, AGA design-certified commercial flexible connector of at least 1/2” (1.3 cm) ID NPT (with suitable strain reliefs) in compliance with ANSI Z21.41 and Z21.69 standards. Leak testing of the appliance shall be conducted according to the manufacturer’s instructions.
/ Gas connection PRESSURE REGULATOR Since service pressure may fluctuate with local demand, every gas cooking appliance must be equipped with a pressure regulator on the incoming service line for safe and efficient operation. The pressure regulator shipped with the appliance has two female threads ½” NPT. The regulator shall be installed properly in order to be accessible when the appliance is installed in its final position.
/ Installation INSTALLATION APPLIANCE INSTALLATION Unpacking the range • Remove all packing materials from the ship- • • • • ping pallet but leave the adhesive-backed foam layer over brushed-metal surfaces to protect it from scratches until the range is installed in its finalposition. Only the film on the side panels should be removed before inserting the range between the cabinets. Examine the appliance after unpacking it. In the event of transport damage, do not plug it.
/ Installation INSTALLING THE LEGS Bertazzoni ranges must be used only with the legs properly installed. Four height-adjustable legs are supplied with the range in the polysterene container situated over the appliance. Before installing the legs, position the appliance near its final location as the legs are not suitable for moving the appliance over long distances. After unpacking the range, raise it enough to insert the legs in the appropriate receptacles situated on the lower part of the appliance.
/ Installation INSTALLING THE ISLAND TRIM INSTALLING BACKGUARD (OPTIONAL) The island trim must be installed prior to operation of the appliance for appropriate ventilation of the oven compartment. The island trim is only placed on the cooktop, remove all tape and packaging before installing it. The backguard must be installed prior to operation of the appliance for appropriate ventilation of the oven compartment. The backguard is an optional contact you dealer for buying it.
/ Installing the anti/tip devices INSTALLING THE ANTI/TIP DEVICES ANTI-TIP BRACKETS ANTI/TILT CHAIN The anti-tip bracket shipped with the range must be properly secured to the rear wall as shown in the picture below. The height of the bracket from the floor must be determined after the range legs have been adjusted to the desired height and after the range has been levelled. Measure the distance from the floor to the bottom of the anti-tip bracket receptacle on the back of the appliance.
/ Gas conversion GAS CONVERSION Warning! Before carrying out this operation, disconnect the appliance from gas and electricity. Gas conversion shall be conducted by a factory-trained professional. Call the customer service hotline to identify a factory-trained professional near your home.
/ Gas conversion Remove the screw located on the right side of the burner and pull out the burner from its support. ATTENTION: pay extra attention to avoid damage to the igniter and thermocouple. 3 Step 3: oven burner (main or auxiliary) To replace the nozzles of the main oven burner, start by removing the door and the bottom panel of the oven. Unscrew the nozzle located inside the gas fitting using a 7 mm [ socket wrench]. Replace the nozzle as table number 1.
/ Gas conversion Step 4: broiler burner Remove the screw and pull out the burner from its support. ATTENTION: pay extra attention to avoid damage to the igniter and thermocouple. primary icone are normal. The flame should burn completely around the burner cap. If it doesn’t, check that the cap is positioned correctly on the base and that the ports are not blocked. The flame should be stable with no excessive noise or fluttering.
/ Gas conversion For the gas valve of dual burner the choke valve is located on the valve body (fig.20), the A screw adjust the outer ring, the B screw adjust the inner ring. B A OVEN BURNER Reinstall the oven door. Set the oven temperature control knob to the MAXIMUM setting. Close the oven door and operate the oven for at least 10 minutes. Set the knob to the MINIMUM setting . Remove the knob.
/ Installation checklist / final preparation INSTALLATION CHECKLIST A qualified installer should carry out the following checks: Range mounted on its legs Island trim or Backguard attached according to instruction Anti-tip device properly installed Clearance to cabinet surfaces as manufacturer’s guideline Proper ground connection Gas service line connected following manufacturer’s guideline Valves, stoppers and gasket installed between the range and the service line Gas connection tested and free of gas lea
/ Bertazzoni service BERTAZZONI SERVICE Bertazzoni is committed to providing the best customer and product service. We have a dedicated team of trained professionals to answer your needs. If you own a Bertazzoni appliance and need service in the US or Canada please use the following contact information: e-mail: aftersaleservice@bertazzoni.com Telephone - Monday through Friday, 7.30am to 7.30pm EST (except US public holidays).
