Installation Use and Care

7
to the spigot. This pipe is an accessory of
the hood.
Warning: To reduce the risk of re use
only metal ductwork.
Attention: The appliance is provided with a
supply cord, the appliance must be positio-
ned so that the plug is accessible.
Attention : If there are three wires in the
electrical supply cable they must be con-
nected as follows:
Grey/Yellow = ground - White = neutral -
Black = line
Important : The hood manufacturer will
not be responsible for any damage or
loss caused by failure to observe these
instructions.
Important : A damage power supply cord
must be replaced by the service.
WARNING
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the
event of an electrical short circuit , groun-
ding reduces the risk of electric shock by
providing an escape wire for electric current.
This appliance is equipped with a cord ha-
ving a grounding. The plug must be plugged
into an outlet that is properly installed and
grounded.
WARNING : Improper grounding can result
in a risk of electrical shock.
Consult a qualied electrician if the groun-
ding instructions are not completely under-
stood, or if doubt exists as to whether the
appliance is properly grounded.
Do not use an extension cord. If the power
supply cord is too short have a qualied
electrician install an outlet near the applian-
ce.
USING THE COOKER HOOD
The cooker hood should be switched on ei-
ther before or the same as cooking ot frying
commences. The lters are more effective if
the fan is not switched off immediately after
cooking or frying is completed, but only af-
ter a period of some 20-30 minutes. Before
using the cooker hood please ensure that all
plastic lms like on metal grease lter and
stainless steel ducting are removed.
INSTALLATION INSTRUCTIONS
This hood has been arranged to be installed
above a cook top. It can be used in 2 ways:
•EXHAUST MODE: the kitchen vapours are
puried by the metal anti-grease lters and
carried outside through a ducting system.
(A-B)
INSTALLATION
The appliance must be installed at a mini-
mum height of 650 mm from an electric coo-
ker stove, or 750 mm from gas or combined
cooker stoves. (Fig.1)
If a connection tube composed of two parts
is used, the upper part must be placed out-
side the lower part.
Do not connect the cooker hood exhaust to
the same conductor used to circulate hot air
or for evacuating fumes from other applian-
ces generated by other than an electrical
source.
MOUNTING THE COOKER HOOD TO THE
WALL
Drill holes A-B-C according to indications
quoted in (g.1).
Use screws and screw anchors suitable for
wall (e.g. reinforced cement, plasterboard)
for the mounting of the cooker hood. Where
screws and screw anchors are supplied
ensure that they are suitable for the type
of wall where the cooker hood is to be
mounted.
Ax the bracket Z to the wall via the drill
holes C
Hang the cooker hood on the wall using the
drill holes A.
Fasten the cooker hood using the fastening
drill holes B.