Installation Use and Care

8
EXHAUST VERSION
Connect the ange Y to the discharge ope-
ning with a connecting tube Fig.5 (do not
carry out for lter version) .
Thread the upper connector E to the inside
of the lower connector F; hang the two
connectors inserting them vertically on the
cooker hood, unthread the upper connec-
tor E towards the top, locking it in with the
appropriate screws in the drill holes G of the
bracket Z (g. 7) previously axed to the
wall via the drill holes C (g. 1).
RE-CIRCULATING VERSION
In order to transform your cooker hood
from the exhaust version to the re-circu-
lating version, ask your local retailer for
active carbon lters and then carry out the
following instructions.
The lters must be applied to the suction kit
located inside the cooker hood (g. 6). The
air is replaced in the environment via the
eyelets impressed on the connector E.
CONTROL PANEL
A B C D E
A- Fan-off
B- First speed (minimum)
C- Second speed (medium)
D- Third speed (maximum)
E- Light ON/OFF
MAINTENANCE
Caution! Before any cleaning or maintenance
disconnect the hood from the mains by
removing the plug or disconnecting the main
switch of the dwelling.
Cleaning
The cooker hood should be cleaned regu-
larly (at least with the same frequency with
which you carry out maintenance of the fat
lters) internally and externally. Clean using
the cloth dampened with neutral liquid de-
tergent. Do not use abrasive products. DO
NOT USE ALCOHOL!
WARNING: Failure to carry out the basic
cleaning recommendations of the cooker
hood and replacement of the lters may
cause re risks. Therefore, we recommend
observing these instructions.
The manufacturer declines all respon-
sibility for any damage to the motor or
any re damage linked to inappropriate
maintenance or failure to observe the
above safety recommendations.
Grease lter
Traps cooking grease particles. This must be
cleaned once a month (or when the lter
saturation indication system – if envisaged
on the model in possession – indicates this
necessity) using non aggressive detergents,
either by hand or in the dishwasher, which
must be set to a low temperature and a
short cycle. When washed in a dishwasher,
the grease lter may discolour slightly, but
this does not affect its ltering capacity.
Charcoal lter (lter version only)
It absorbs unpleasant odours caused by
cooking. The saturation of the charcoal lter
occurs after more or less prolonged use,
depending on the type of cooking and the
regularity of cleaning of the grease lter.
In any case it is necessary to replace the
cartridge at least every four mounths (or
when the lter saturation indication system
– if envisaged on the model in possession –
indicates this necessity).The charcoal lter
may NOT be washed or regenerated.
Replacing lamps
The hood is equipped with a lighting system
based on LED technology. The LEDs gua-
rantee an optimum lighting, a duration up
to 10 times as long as the traditional lamps
and allow to save 90% electrical energy. For
replacement, contact the technical service.