Installation Use and Care
5
IMPORTANT SAFETY INSTRUCTIONS
Carefully read the following important information
regarding installation safety and maintenance.
READ AND SAVE THESE INSTRUCTIONS
for
future reference.
REQUIREMENTS:
UL350WAC120V,60Hz3.3ACircuitgrounding.
INTENDED FOR DOMESTIC COOKING
ONLY !
IMPORTANT SAFEGUARDS
- Do not connect the exhaust hood to the
chimneys, ues and airducting the room.
- The evacuated air must not be let into a
warm air duct.
- This appliance must be connected to a sy-
stem equipped with earth or ground plate.
- When performing maintenance operations,
disconnect the appliance from the eld
connection.
- Do not do any ambè cooking underneath
the hood - When frying, never leave the pan
alone because the cooking oil could are up.
- Clean all the surfaces frequently to avoid
danger of re. To do so use a cloth and or
brush soaked in denatured ethyl alcohol.
It also important to remove and clean or
substitute frequently the lter installed in
the hood.
- It advisable to utilise kitchens of the same
width as the hood.
- Do not operate with a damaged cord or
plug. Discard fan or return to an authori-
zed service facility for examination and/or
repair.
- Do not run cord under carpeting. Do not
cover with throw rugs, runners or similar co-
verings. Arrange cord away from trac area
and where it will not be tripped over.
- Do not route cord under furniture or ap-
pliances.
- Do not operate any fan with a damaged
cord or plug. Discard fan or return to an au-
EN
thorized service facility for examination and/
or repair. Do not run cord under carpeting.
- Wiring shall be protected from sharp
edges (including male screw threads), burrs,
ns, moving parts, and other agencies that
might abrade the insulation on conductors.
INTRODUCTION
These instructions are designed to tell you of
the various technical details of your cooker
hood and to make you familiar with its use.
Since these instructions cover more than
one type of hood within the same series, it
may be that reference is made to compon-
ents that do not form part of the hood that
you are installing. The hood should be used
in the exhaust version to discharge all the
kitchen vapours and odours out-door of the
building. Fittings can vary from country to
country. We reserve the right to modify the
product without any notice always with the
aim of improvements and in compliance with
the relevant norms.
SUGGESTIONS FOR USING THE HOOD IN
EXHAUST POSITION
When an exhaust hood and a heat source
requiring ambient air (e.g. gas, oil, coal
stoves, etc.) are used at the same time,
attention is required because the air neces-
sary for combustion is exhausted from the
room through the hood and this creates
depression. There is no such danger when
the maximum depression in the room is
0,04 mbar. In this condition no exhaust gas
from the heat source is piped. To assure this
condition, make opening in the room which
cannot be closed (doors, windows, etc. are
insucient) and through which the air ne-
cessary for combustion can freely ow.
Note : All the exhaust ductwork in the
apartment or house should be studied. In
case of doubts, get advice or authorization
from the person or agency responsible for
the building.
Note : The eciency of the exhaust hood
decreases as the length of the ducts and
number of increase. When using the
exhaust version, follow these rules : Do not
connect the exhaust hood to chimneys,