Installation Guide

• Next, secure mounting plate to the wall by tightening toggle

bolt assemblies or lag screw(s). See Figure 21.

Figure 21

• Drill

/16” diameter lag screw hole(s), into one or more wall

studs.

(Remember, you must have at least one lag screw

secured to a wall stud.) For stud location refer to WALL

CONSTRUCTION, see page 3.

• Tighten the lag screw(s) into wall stud(s).

Mounting Oven to The Wall

NOTE: IT IS VERY IMPORTANT THAT THIS OVEN BE

INSTALLED BY TWO PEOPLE.

IMPORTANT: DO NOT GRIP OR USE HANDLE DURING

INSTALLATION.

Preparation of Top Cabinet

You need to drill holes for the top support screws and a hole

large enough for the power cord to t through.

Read the instructions on the TOP CABINET TEMPLATE.

Tape it underneath the top cabinet.

Drill the holes, following the instructions on the template.

NOTE: TOP CABINET TEMPLATE instruction must be

installed to proceed.

STEP 1

• Protect the top of your range by placing a portion of the

carton or some other heavy material over the cooking

surface before mounting your oven.

STEP 2

• Lift the microwave oven and tilt it forward.

• Hang the unit on two tabs at the bottom of the mounting

plate. See Figure 22.

Figure 22

STEP 3

• Thread power cord through the hole at the bottom of the

top cabinet.

• Swing the unit upward to meet the top of the mounting plate

and hold it securely. See Figure 23.

Figure 23

STEP 4

• Insert a bolt through the provided washer and then through

each hole in the upper cabinet bottom.

• Tighten the bolts until the gap between the upper cabinet

and microwave oven is closed. See Figure 24.

Figure 24