Installation And User Guide

1. Place a bracket

on the wall as shown about 1/8" from the ceiling or

upper limit, aligning the center (notch) with the vertical reference line

and mark the wall at the centers of the holes in the bracket.

2. Place the second bracket

on the wall as shown, below the rst

bracket, at the height of the upper chimney section

supplied and

aligning the center (notch) with the vertical line.

3. Mark the wall at the centers of the holes in the bracket and mark the

point 1 and 2 for the Hood Body installation as shown(12 5/8" from the

horizontal line and 4 9/16" from the vertical line).

4. Drill ø 5/16" holes at all the center points marked (point 1,2,3,4,5,6) as

shown.