Installation And User Guide

Now take either your wood screws or bolts depending on your set-up and screw all four

into the pilot holes and leave 1/4" of the heads exposed.

Next install a UL or CSA listed strain relief in the wiring box so that the screws can be

tightened after the chimney support is attached to the ceiling.

Now lift the chimney support into it's nal position and feed the electrical supply through

the strain relief.

Next position the chimney support so that the large end of the keyhole slots are over

the ceiling attachment screws or bolts. Then push the chimney support so that the bolts

are in the neck of the slots. Tighten all four screws or bolts securely.

• The frame mountings must be secure to withstand the weight of the hood and any

stresses caused by the occasional side thrust applied to the device. On completion,

check that the base is stable, even if the frame is subjected to bending.

• In all cases where the ceiling is not strong enough at the suspension point, the installer

must provide strengthening using suitable plates and backing pieces anchored to the

structurally sound parts.







12q