CHIMNEY HOOD INSTALLATIONS INSTRUCTIONS HOTTE DE CHEMINÉE INSTRUCTION POUR LE MONTAGE MODELS KU24 PRO 1X KL1A.HM4X..UA KU30 PRO 1X K71A.HM4X..UA KU36 PRO 1X K31A.HM4X..UA KU48 PRO 1X K41A.HM4X..
Fig. 1 fig.3 Fig.
fig.
CHIMNEY HOOD INSTALLATIONS INSTRUCTIONS Important safeguards - Do not connectthe exhaust hood to chimneys, flues and airductsserving the room. - The evacuated air must not be let into a warm air ducl. - This appliance must be connected to a system equipped with earth or ground plate. - When performing maintenance operations, disconnect the appliance from the field connection. - Do not do any flambé cooking underneath the hood. - When frying, never leave the pan alone because the cooking oil could flare up.
WARNING: TO REDUCE THE RISK OF FIRE, USE ONL Y METAL DUCTWORK. Attention:The appliance is provided with a supply cord and plug, the appliances must be positioned so that the plug is accessible. Attention: ifthere are three wires in the electrical supply cable they must be connected as follows: Green/yellow = ground -White = neutral -Black = line Important: the hood manufacturerwill not be responsible forany damage or loss caused by failure to observe these instructions.
Replacing or cleariing the filters Just push the handle towards the rear, proceed with the cleaning and repeat the operation counter clockwise (Picl. 1/1). To remove the aluminium grease filter (Picl. 1/2), grab the opening tongue at the filter, pull it in your direction and move the filterdownwards. To reinstall it operates reversed. 1)READ AND SAVE THESE INSTRUCTIONS 2)WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: A. Never leave surface units unattended at high settings.
HOTTE DE CHEMINÉE INSTRUCTION POUR LE MONTAGE Précautions importantes à suivre: - Ne pas lier la hotte à cheminée, tubes et conduits d'air indispensable-à la pièce. - L'air qui est aspirée ne doit pas etre émis par un conduit d'air chaud. - Cet appareil doit etre joint à une installation qui se fournit à terre ou par une évacuation à terre. - Durant le nettoyage de l'appareil il est préférable débrancher la prise de courant. . - Ne pas effectuer de cuisson à fiamme haute sous la hotte.
Branchement de la partie aspirante. Si vous avez le modèle aspirant, il est nécessaire de joindre à la coque un conduit de Ø 150 mm ( 5" 29/32) ou de Ø 125 mm ( 4"59/ 64), qui permettra la prise d'air. Ce conduit n'est pas fournit avec le matériel, ( Fig.4 e 4/M). Attention pour réduire le risque d'lncendie, n'utiliser que des conduits en métal. S'assurer que toutes les parties soient fixées correctement et que celles en mouvement soient bien protégées.
Changement ou nettoyage. Il suffit simplement de tirer la poignée vers le bas pour pouvoir nettoyer celle-ci et fai re à nouveau la meme opération en sens inverse (Fig. 1/1). Pour enlever le filtre en aluminium (Fig.1/2), prendre le filtre à la languette d'ouverture, la plier vers soimeme et abaisser le filtre en avant, faire à nouveau le meme procédé en sens inverse pour le repositionné.