manual
4
TABLE N°1: Adaption to various types of gas APPLIANCE CATEGORY: II2H3+
Brännare Gastyp Tryck Diameter
munstycke
Nominell kapacitet Reducerad
kapacitet
Diameter
by-pass
mbar 1/100 mm g/h l/h kW kcal/h kW kcal/h 1/100 mm
Naturgas G20 20 77 - 95 1,00 860 0,48 413 34 jus.
Stads gas G110 8 145 - 227 1,00 860 0,48 413 34 jus.
Extra Stads gas G120 8 135 - 203 1,00 860 0,48 413 34 jus.
Butangas G30 28-30 50 73 - 1,00 860 0,48 413 34
Propangas G31 37 50 71 - 1,00 860 0,48 413 34
Naturgas G20 20 101 - 167 1,75 1505 0,6 516 36 jus.
Stads gas G110 8 192 - 397 1,75 1505 0,6 516 36 jus.
Halvsnabb Stads gas G120 8 180 - 355 1,75 1505 0,6 516 36 jus.
Butangas G30 28-30 66 127 - 1,75 1505 0,6 516 36
Propangas G31 37 66 125 - 1,75 1505 0,6 516 36
Naturgas G20 20 129 - 286 3,00 2580 1,05 903 52 jus.
Stads gas G110 8 280 - 681 3,00 2580 1,05 903 52 jus.
Snabb Stads gas G120 8 260 - 608 3,00 2580 1,05 903 52 jus.
Butangas G30 28-30 87 218 - 3,00 2580 1,05 903 52
Propangas G31 37 87 214 - 3,00 2580 1,05 903 52
Naturgas G20 20 70 - 76 0,80 688 0,48 413 34 jus.
Dual Stads gas G110 8 130 - 181 0,80 688 0,48 413 34 jus.
Inre Stads gas G120 8 130 - 162 0,80 688 0,48 413 34 jus.
Butangas G30 28-30 46 58 - 0,80 688 0,48 413 34
Propangas G31 37 46 57 - 0,80 688 0,48 413 34
Naturgas G20 20 2x110 - 419 4,40 3784 1,8 1548 65 jus.
Stads gas G110 8 2x300 - 419 4,40 3784 1,8 1548 65 jus.
Dual Stads gas G120 8 2x290 - 419 4,40 3784 1,8 1548 65 jus.
Yttre Butangas G30 28-30 2x69 298 - 4,10 3526 1,8 1548 65
Propangas G31 37 2x69 293 - 4,10 3526 1,8 1548 65
Naturgas G20 20 150 - 429 4,5 3870 2 1720 70 jus.
Ugn
Butangas G30 28-30 95
327 - 4,5 3870 2 1720 70
Propangas G31 37 95 321 - 4,5 3870 2 1720 70
BURNER ADJUSTMENT
1)Primary air adjustment:
Oven burner adjustment: follow the instructions below to adjust the primary air for the over burner:
1) Remove the oven bottom.
2) Loosen the screw P and adjust the position X of the Venturi cone (Fig. 15) according to the measurements indicated in
table 2.
TABLE N°2: Burner primary air regulation (indicative)
BURNER
Type of gas Oven (mm)
Natural G20 fully open
Butane G30 fully open
Propane G31 fully open
2) Burner "MINIMUM" adjustment:
Work surface burner adjustment: follow the instructions below to adjust the work surface burner minimum:
1) Light the burner and set the knob to the MINIMUM position (small flame).
2) Remove the knob of the valve that is press fit on the rod of that valve.
3) If the cooker is not equipped with safety valves on the surface burners, insert a small slotted screwdriver into the hole
on the valve rod (Fig. 16) and turn the choke screw to the right or left until the burner flame is adjusted to minimum. If the
cooker is equipped with safety valves, the choke valve is not located in the rod hole, but on the valve body (see fig. 17).
4) Make sure that the flame does not go out when switching quickly from the MAXIMUM to the MINIMUM position.
Oven burner adjustment: follow the instructions below to adjust the minimum:
1) Light the burner setting the knob to the MAXIMUM position.
2) Close the oven door and operate the oven for at least 10 minutes.
3) Set the knob to the MINIMUM position (corresponding to 120°) and then remove it.
4) With a slotted screwdriver turn the choking screw (see figure 18) and, while observing the flame at the same time
through the cooker porthole, evaluate the consistency of the flame so it remains on when switching quickly from the
MINIMUM to the MAXIMUM position.
WARNING: The above-mentioned adjustment should be made only with methane gas burners, while for those
operating with liquid gas the screw must be locked at the end in a clockwise direction. The grill
burner always operates at maximum and therefore no minimum adjustment is required.
APPLIANCE ELECTRIC CONNECTION:
The electric connection must comply with the current legal standards and regulations.
Before making the connection, check that: