Range User Manual

28
MAINTAININGYOURRANGE
REPLACINGTHEOVENLIGHTBULB
WARNING!
Disconnectpowerbeforeservicingunit.
To replace the oven light bulb, unscrew the
protectioncapthatprojectsoutinsidetheoven.
Spare bulbs are available at factoryauthorized
partsresellerslistedonpage4.
Alternatively use commercial bulbs type [list
SPECS]
COOLINGFANFAILURE
Bertazzoni ranges are equipped with a cooling
fan. The fan starts operating each time theoven
knobisonapositiondifferentfrom0(zero).
The fancirculates the air between the control
panel and the oven door, allowing the control
panel and the oven door
to remain cool while
cooking.
Malfunctionofthecoolingfanisindicatedbythe
FANFA ILURElight situatedat the left side ofthe
control panel. If the light is on, turn off all
burnersassoonaspossibleandcallthecustomer
service hotline to schedule service by a factory
trainedprofessional.
CLEANINGYOURRANGE
ATTENTION!
Neveruseabrasivecleaners!
Scratchesonthestainlesssteelsurfacesare
permanent.
Donotcleantherangewhenhot!
Cleaning after installation: use a stainless steel
cleaning product or wipe to eliminate the glue
residues of the blue protection film after
removal.
Cleaning the worktop: periodically clean the
burner
heads,thecastironpansupportsandthe
burner caps using warm water. Remove burned
food and fat residues with a rubber spatula . If
food residue prevent the smooth operation of
the control knobs, call the customer servce
hotline to schedule service by a factorytrained
professional.
Cleaning stainless steel:
for best results use a
stainlesssteelcleanerproductwithasoftsponge
or wipe. Al ternatively use a soft sponge or cloth
witha warm soap andwatersolution. Neveruse
abrasivepowdersorliquids!
Cleaning the burner caps: lift the burner caps
fromtheburnerheadsandwashthem
inawarm
soap and water solution. Dry thoroughly before
usingthemagain.Beforereinstallingthemonthe
burner head, check that the gas flow holes are
not clogged with food residues or cleaning
productresidues.
Cleaning Enamel: enamelled parts should be
cleaned frequently with awarm soap and water
solution applied
with a soft sponge or wipe.
Never use abrasive powders or liquids! Do not
leave acid or alkaline substances on the
enamelled parts (such as vinegar, lemon juice,
salt,tomato sauce,etc.). Usearubber spatulato
removefatresidues.
Cleaning glass door: cleanthe glass using a non
abrasive
sponge or wipe with a warm soap and
warm water solution. Use a rubber spatula to
removefatresidues.
Cleaning the inside of the oven glass: Oven
feature is the ability to remove the inner glass.
Afteryouopenthe doorcompletelyand lockthe
hinges (fig. 1) unhook the
engagements shows
the figure (23) lift and remove the inner glass
(fig. 4) and then clean thecrystal. Such an
operation is to be performed in cold oven and
with a damp cloth, taking care not to use
abrasives. To reassemble the glass do the