Range User Manual

7

BEFOREINSTALLATION
This appliance shall only be installed by an
authorizedprofessional.
This appliance shall be installed in accordance
withthemanufacturer’sinstallationinstructions. 
This appliance must be installed in accordan ce
withthenorms&standardsofthecountrywhere
it will be installed. The installation of this
appliance must conform to local
 codes and
ordinances. In the abs ence  of local codes,
InstallationsmustconformstoAmericanNational
Standards,National FuelGasCodeANSIZ223.1–
latestedition**orB149.1.
The appliance, when installed, must be
electrically grounded in accordance with local
codes or, in the absence oflocal codes, with the
National
ElectricalCode,ANSI/NFPA70.
If local codes permit, a flexible metal appliance
connection with the new AGA or CGA certified
design, max. 5 feet (1,5 m) long, ½” I.D. is
recommended for connecting this appliance to
the gas supply line. Do not bend or damage the
flexibleconnectorwhenmovingthe
appliance.
This appliance must be used with the pressure
regulator pr ovided.  The regulator shall be
properlyinstalledin  orderto beaccessible when
theappliance  is installed initsfinal location. The
pressureregulatormustbesetforthetypeofgas
tobeused.Thepressureregulatorhas½”
female
pipe thread. The appropriate fitting must be
determined based on the sizeof yourgas supply
line,theflexiblemetalconnectorandtheshutoff
valve.
The appliance must be isolated from the gas
supply piping system by closing its individual
manualshutoffvalveduring anypressuretesting
ofthegas
supplypipingsystemattestpressures 
equaltoorlessthan½psi(3.5kPa).
All opening and holes inthe wall and floor, back
and under the appliance shall be sealed before
installationoftheappliance.
Amanual valveshall beinstalledinan accessible
location in the gas
line external to the appliance
for the purpose of turningon or shutting off gas
totheappliance

WARNING!
Donotuseaerosolspraysinthevicinityofthis
appliancewhileitisinoperation
ROOM VENTILATION: An exhaust fan may be
used with the appliance; in each case it
shall be
installed in conformity with the appropriate
national and local standards. Exhaust hood
operationmayaffect other ventedappliances; in
each case it shall be installed in conformity with
theappropriatenationalandlocalstandards.

TYPEOFGAS
Thisapplianceisshippedfromthefactoryforuse
with LP
gas. For use with Natural gas please
followtheconversionproceduredescribedonpg.
17. A step by step conversion procedure is  also
includedwitheachsetofNaturalgasnozzles.

GASPRESSURE
Themaximuminletgassupplypressureincoming
to the gas appliance pressure regulator is 20’’
watercolumn
(5kPa).
The minimum gas supply pressure for checking
theregulatorsettingshallbeatleast1“w.c.(249 
Pa)abovetheinletspecifiedmanifoldpressureto
theappliance (thisoperatingpressureis 11”w.c.
(2.75kPaforLPGas)and4”w.c.(1.00kPa)for
NaturalGas.


