Installation, Use & Care Manual

9
/ Clearence dimensions
CLEARENCES DIMENSIONS
Installation adjacent to kitchen cabinets
This cooktop may be installed directly adjacent to
existing countertop high cabinets (36” or 91.5 cm
from the fl oor).
For the best look, the worktop should be level with
the cabinet countertop. This can be accomplished
by raising the unit using the adjustment spindles
on the legs.
ATTENTION: the cooktop CANNOT be installed
directly adjacent to kitchen walls, tall cabinets, tall
appliances, or other vertical surfaces above 36”
(91.4 cm) high. The minimum side clearance in
such cases is 6” (15.2 cm).
Wall cabinets with minimum side clearance must
be installed 18” (45.7 cm) above the countertop
with countertop height between 35 ½” (90.2 cm)
and 37 ¼” (94.6 cm). The maximum depth of wall
cabinets above the rangetop shall be 13” (33.0
cm).
Cabinet
Shaded area behind cooktop indicates minimum
clearance to combustible surfaces, combustible
materials cannot be located within this area.
12” (305 mm) min. to combustible surface with
Flush Island Trim
For Flush Island installations, counter surface
should have a cantilever edge meeting the back
section of the Flush Island Trim accessory.
As defi ned in the “National Fuel Gas Code” (ANSI
Z223.1, Current Edition).
Clearances from non-combustible materials are
not part of the ANSI Z21.1
scope and are not certifi ed by CSA. Clearances of
less than 12” (305 mm) must be approved by the
local codes and/or by the local authority having
jurisdiction.
Metal hood
B
H
min 25” 1/2 (65 cm)
min 12” (30,50 cm)
B
H
COOKTOP 30” COOKTOP 36”
L1 20” 1/2 (52 cm) 20” 1/2 (52cm)
L2 1” 9/16 (4 cm) 1” 9/16 (4cm)
L3 2” 3/16 (5,5cm) 2” 3/16 (5,5cm)
L4 18” (45,7cm) 18” (45,7cm)
L5 25” 3/16 (64 cm) 25” 3/16 (64 cm)
L6 13” (33cm) 13” (33cm)
L7 29” 7/16 (74,8cm) 36” 7/16 (92,5 cm)
L8 3” 1/8 (8cm) 3” 1/8 (8cm)
L9 6” 1/4 (16cm) 6” 9/16 (16,6cm)
L10 28” 15/16 (73,5cm) 35” 5/8 (90,5cm)
L11 36” (91,5cm) 36” (91,5cm)