Installation Sheet
38
TROUBLESHOOTINGGUIDE
OVENPROBLEM POSSIBLECAUSESAND/ORREMEDY
Rangedoesnotfunction Range is notconnectedto electricalpower. Aska professionalto check
powercircuitbreaker,wiringandfuses.
Self‐cleancycledoesnotactivate Doorisnotshuttightenoughforautomaticdoorlatchtolock
Broildoesnotwork Temperature controlknob isrotated toofarpast broil position(500°F);
PRE‐HEATINGindicatorwilllightintermittently
Doordoesnotopen Oven is still in self‐clean mode. Door latch will release when safe
temperatureisreached.
Ovenlightdoesnotwork Lightbulbisburnedout.Rangeisnotconnectedtopower/cleaniscycle
on
Ignitersdoesnotwork Circuitistrip ped.Fuseisblown.Rangeisnotconnectedtopower.
Igniters sparking but no flame
ignition
Gassupplyvalveisin“OFF”position.Gassupplyisinterrupted.
Igniters spark continuously after
flameignition
Ignition micro‐switches remain incorrectly engaged; call a qualified
technicianforrepair.
Burnerignites butflame is large,
distorted,oryellow
Burnerportsareclogged.Unitisnotsettotheappropriategastype.Call
aqualifiedtechnicianforgasconversionprocedure.
Oven door is locked and will not
release,evenaftercooling
Turntheovenoffatthecircuitbreakerandwait5minutes.Turnbreaker
backon.Theovenshouldresetitselfandwillbeoperable.
Ovenisnotheating
Checkthecircuitbreakerorfuseboxto yourhouse.Makesurethereis
proper electrical power to the oven. Make sure the oven temperature
hasbeenselected.
Oven light is not working
properly
Replaceorreinsertthelightbulbiflooseordefective.
Ovenlightstayson Checkforobstructioninovendoor.Checktoseeifhingeisbent.
Cannot remove lens cover on
light
Theremaybesoil buil d‐uparoundthelenscover.Wipelenscoverarea
withacleandrytowelprior toattemptingtoremovethelenscover.
PRE‐HEATING indicator lights up
intermittently and sound alarm
on
This is a FAULT alarm indicating the failure of the cooling fan/s. Try
resettingbyturningbothselectorstotheOFFposition.Iftheerrorisnot
repaired, call a qualified technician for diagnosis and repair. If not
repaired, this error
indicator will appear again within 10 seconds once
theovenisactivatedinany functionsforwhichcoolingfansarerequired
to operate, preventing the use of the oven. Set both selectors to OFF
positionandcallaqualifiedtechnicianforrepair.
HEATING indicator light turned
onintermittentlyandwithsound
alarmon
ThisisaFAULTindicatingfailureoftheovensensortemperatureprobe;
in this case cooling fans will start automatically. To reset, switch both
selector to the OFF position.To stop buzzer and light indicator,
disconnect the appliance from the
main electrical supply and call a
qualifiedtechnicianforrepair.
CLEAN indicator light on
intermittently and sound alarm
on
Electrical power failure happening during cleaning cycle operation;
cleaning cycle interrupted; cooling fans remains both activated; the
error will be reset by putting two selectors in OFF position; repeat
cleaningcycleifneededafter3‐4hours.