F1 CAR SEAT ECE R44/04 GROUP I, II (9-25 kgs) MANUAL INSTRUCTION
EN IMPORTANT! KEEP FOR FURTHER REFERENCES. READ CAREFULLY! Only suitable if the approved vehicles are fitted with 3-points static or 3-point retractor safety-belts. Approved to UN/ECER Regulation No. 16 or other equivalent standarts.
MAINTENANCE AND CLEANING 1. The car seat can be cleaned using lukewarm water and soap. Do not use aggressive cleaners like abrasives or thinner. 2. The cover should be washed by hand at a maximum temperature of 30oC. Do not put in the dryer. Step 1. Take the car seat out of your car. step 2. Clean food particles and dirt with a vacuum. If possible, use a vacuum cleaner’s furniture attachment to clean the small, hard-to reach areas of the car seat. Step 3.
FEATURES 1. Fabric Cover 2. Hook 3. Shell 4. Shaft and Lock 5. Lock-off Device 6. Instruction Manual Storage 7. Lap Belt Indicator 8. Installation Sticker 9. Belt Yoke 10. Belt Guider 11. Base 12. Backrest 13. Head Pillow 14. Belt Slots 15. Belt Pads 16. Shoulder Belt 17. Buckle 18. Crotch Strap 19. Cushion 20. Center Adjuster 21. Adjuster Cover 22. Positioning Handle 23.
INSTALLATION The car seat “F1” can only be used with an automatic 3-point safety belt. (Fig.1) The car seat “F1” can be used in five position (Fig.2): Pull the positioning handle under the front of the seat forwards or backwards (feel the spring underneath), release the handle on your required position while hearing a distinct click. Fig.1 Fig.2 INSTALLING THE CAR SEAT group I /9-18 kg/ 1. Place the car seat in the sleeping position 3 or 4. (Fig. 3) 2.
INSTALLING THE CAR SEAT group II /15-25 kg/ This installation method is for child within Group ІI (15 – 25 kg). 1. Remove the harness system first, including thee belt pads, buckle and crotch strap.. 2. Install the shoulder and lap belt by threading the vehicle’s lap and shoulder belt through the hook (Fig.6-А) on the top of shell and over the belt guider. (Fig.6-7) Fig.6-A Fig.6 Fig.7 PLACING YOUR CHILD IN THE CAR SEAT 1.
ADJUSTING THE HEIGHT OF THE SHOULDER BELTS 1. The correct belt height of the shoulder belts is attained when the belt disappears into the shell slightly above the shoulder of the child. Ensure that the shoulder belts fit comfortably over the child’s shoulder. (Fig.15) 2. Loosen the shoulder belts by pressing the push button of the adjuster and pulling the shoulder belts towards you as far as possible. Important: Do not pull the belt pads when doing so. (Fig.9) 3.
Дидис ООД - България Шумен 9700, “Правда” 1 Тел.: 054/850 830 Факс: 054/850 839 e-mail: office@didis-ltd.com Didis Ltd. - Bulgaria Shumen 9700, “Pravda” 1 Str. Tel.: +359 54 850 830 Fax: +359 54 850 839 e-mail: office@didis-ltd.com www.bertoni-eu.
