PILOT CAR SEAT GROUP 1 (9-18 kg) MANUAL INSTRUCTION
EN IMPORTANT! KEEP FOR FURTHER REFERENCES.
INSTALLATION OF THE SEAT IN A CAR Note: The child restraint is only suitable for use with lap/3-point safety belts, approved to ECE R16 or equivalent standards. RECLINE POSITION ADJUSTMENT Note: There are three feasible positions when using the car seat in a vehicle: upright, middle and inclined. See / Fig.I / To achieve that use the lever located in front of the child restraint. Pull the lever out and hold it at the same time pull back or forward the sitting part of the child restraint.
ADJUST THE LENGTH OF HARNESSES Shoulder belts Buckle tongue Buckle In order to protect you child much better, after fix him/her in the child restraint and lock the buckle, you should tighten the harnesses so they are snug and flat against the child’s body. They should never be twisted or loose. 1.To tighten the harnesses press the button located on front side of the seat (7a) and pull the adjustable strap (located on front side of the seat too) out from the lock (7b). See / Fig.
REMOVING THE SEAT FROM THE VEHICLE To remove the seat from the vehicle follow the steps below: - unbutton the belt of the vehicle. - pull the safety belt of the vehicle through the openings on the car seat. - remove the car seat from the vehicle. ( VIII ) CHANGING THE HEIGHT OF HARNESSES To change the position of the shoulder belts follow the steps below: - release the shoulder belts from the metal clip located on the bottom side of the base of the seat.
Дидис ООД - България Шумен 9700, “Правда” 1 Тел.: 054/850 830 Факс: 054/850 839 e-mail: office@didis-ltd.com Didis Ltd. - Bulgaria Shumen 9700, “Pravda” 1 Str. Tel.: +359 54 850 830 Fax: +359 54 850 839 e-mail: office@didis-ltd.com www.bertoni-eu.
