20 1 21 2 4 3 5 7 REARWARD-FACING 6 8 11 12 USER MANUAL 13 14 23 22 10 9 15 16 18 17 24 25 19 ECE R44 04 GROUP 0+/1/2 WEIGHT 0-25 kg 2x AGE 6m-5y 2x 2x
6 27 32 31 37 38 Thank you for choosing BeSafe iZi Plus BeSafe has developed this seat with much care, to protect your child during the first phase of her or his life. !! It is important that you read this user manual BEFORE installing your seat. Incorrect installation could endanger your child.
Rearward-facing belt installation Crucial parts 1. Adjustable head rest 2. Shoulder straps (2x) 3. Body hugger 4. Harness buckle 5. Central adjuster 6. Reclining lever 7. Front brace 8. Belt guiding hook 9. Ratchet for front brace 10. Belt guiding horns (2x) 11. Floor support 12. Height adjuster floor support 13. Floor support height indicator 14. Anchor belt (2x) 15. Release handle head rest 16. Floor support position indicator 17.
With the anchor belts in place the installation can continue: 1. Place the seat sideways into the car with the front brace towards you. 2. Turn the seat into the right position (with the front brace against the back rest). 3. Position the floor support around 5cm. above the floor. 4. The height indicator of the floor support shows grey when the floor support is above the floor. (23) 5. In the front seat of the vehicle, you should position the seat against the dashboard.
Removing the seat 1. If the seat is installed in the back seat of the vehicle, push the front seat of the vehicle forward as much as possible. 2. Move the front brace inwards with the ratchet. 3. Move the floor support to the highest position. 4. Release the anchor belts. 5. Remove the car belt from the front brace and the seat base. 6. Pull the seat back towards the front. Turn the seat so you can easily remove the seat. 7. Remove the anchor belts from the vehicle. Positioning the child 1.
Removing and refitting the cover Removing the cover • Pay attention when you remove the cover, as fitting the cover is done in the opposite way. • Start to take off the lower seat part. (40) • The cover of the head rest can be taken off separately by disconnecting the hooks at the backside and pulling off the fabric to the front. Refit the cover • Pull the head rest in the highest position. Mount the head rest cover and connect the hooks at the back side. Pull the harness straps through the holes.
Guarantee • Do not use any aggressive cleaning products; these may harm the construction material of the seat. • BeSafe advises that child seats should not be bought or sold second-hand. • KEEP this user manual for later use with the seat. • DO NOT use at home. It has not been designed for home use and can only be used in a vehicle. Practical advice When the child seat is mounted in the car check all the areas where the child seat might touch the interior.
B109-8814 N2002082
