Service manual

Installation Instructions for B.A.S.I.S. Cylindrical Locks
BEST ACCESS SYSTEMS
Indianapolis, Indiana
11
Installation Instructions for B.A.S.I.S. Cylindrical Locks
Completing the installation
17 Install core and throw member
1 Install the blocking plate onto the throw member.
Caution: You must use the blocking plate to
prevent unauthorized access.
2 Insert the control key into the core and rotate the key
15 degrees to the right.
3 Insert the throw member into the core.
4 Insert the core and throw member into the lever with
the control key.
5 Rotate the control key 15 degrees to the left and
withdraw the key.
Caution: The control key can be used to remove
cores and to access doors. Provide adequate
security for the control key.
18 Install battery compartment door
1 Making sure that the battery compartment door
does not pinch any wires, insert the tabs of the
battery compartment door into its mating slots and
swing the door closed.
2 Use a T15 TORX bit driver to secure the battery
compartment door with the security screw. Tighten
firmly.
Figure 17a Installing the blocking plate and throw membe
r
Core
Blocking
plate
Throw
member
Figure 17b Installing the core
Core
Control
key
Throw
member
Figure 18 Installing the battery compartment door
Tabs
Security
screw