Instructions / Assembly

It is important that the floor be level and square.
Before nailing the flooring, measure the floor
diagonally (corner to corner). Then measure
the opposite corners. These measurements will
be the same if the floor is square (173").
2. Cut 2x4-8' floor joists to a length of 7'-9". Treated lumber may be thicker than 1-1/2".
Take this into account when cutting the length of floor joists. Shorten joist measurements
if necessary to obtain 8'-0" building width.
1. Treated lumber is not cut to exact length. Cut (2) two 2x4-12' boards to 12'-0".
Layout for 16" on center joist spacing. 'X' marks where floor joist will be placed.
Construction Details for Optional Floor System
Check local building codes in your area, the construction may have to change. For a concrete slab,
install sill sealer as a moisture barrier between the concrete and the wall plates. Foam sill sealer can
be purchased at home centers in rolls 3-1/2" or wider.
Material Description 8' x 12' Floor
2x4 Treated Headers 2 pcs. 12'
2x4 Treated Floor Joist 10 pcs. 8'
Flooring 5/8" 4x8 3 pcs. 4x8
8d Screw Floor Nails 1 lb. 8d
16d Galv. Box Nails 1 lb. 16d
If necessary use bricks, patio stones or similar material to level or provide additional support
to the floor. If your ground has low areas consider adding gravel and or 4x4 treated timbers
to rest the floor on. If you use 4x4 timbers you will need (3) three pieces 12' long.
3. Install the floor joists, over the 'X' marks, between the 12' long joist headers. Use 16d galv.
deck nails.
!
!
Joist 7' - 9" Long
2x4-12' Joist Header
12' - 0" Floor Length
8' - 0" Floor W
idth
Leveling Blocks
4' x 8'
4' x 4'
X
X
X
X
X
X
16"15-1/4"
Joist Header
X
X
16"